𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Effect of Controlled Cooling on Microstructure and Mechanical Properties of H-Beam

✍ Scribed by GUO, Fei; ZHAO, Xian-ming; WANG, Li-na; WU, Di; WANG, Guo-dong; NING, Zhong-liang

Book ID
122601148
Publisher
Chinese Electronic Periodical Services
Year
2013
Tongue
English
Weight
455 KB
Volume
20
Category
Article
ISSN
1006-706X

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Effect of cooling rate on microstructure
Effect of cooling rate on microstructure and mechanical properties of gray cast iron
✍ M.M. Jabbari Behnam; P. Davami; N. Varahram πŸ“‚ Article πŸ“… 2010 πŸ› Elsevier Science 🌐 English βš– 965 KB

This paper presents the results obtained and the deductions made from a series of microstructural studies and mechanical tests involving gray cast iron which was sand cast using a variety of modules. The effect of cooling rate on the primary dendrite arm spacing (DAS), secondary dendrite arm spacing

Effect of cooling rate on solidified mic
Effect of cooling rate on solidified microstructure and mechanical properties of aluminium-A356 alloy
✍ L.Y. Zhang; Y.H. Jiang; Z. Ma; S.F. Shan; Y.Z. Jia; C.Z. Fan; W.K. Wang πŸ“‚ Article πŸ“… 2008 πŸ› Elsevier Science 🌐 English βš– 561 KB

A fast-cooling technology using a copper mould cooled by a phase-transition medium was used to prepare cast aluminium-A356 alloy by solidification of the melt. The cooling rate achieved with this technique is in the order of 10 2 K/s. As-cast samples with a diameter of 10 mm were produced. The micro