Effect of compatibilizer on the crystallization, rheological, and tensile properties of LDPE/EVOH blends
β Scribed by Sang Young Lee; Sung Chul Kim
- Publisher
- John Wiley and Sons
- Year
- 1998
- Tongue
- English
- Weight
- 415 KB
- Volume
- 68
- Category
- Article
- ISSN
- 0021-8995
No coin nor oath required. For personal study only.
β¦ Synopsis
The effect of the compatibilizer on the crystallization, rheological, and tensile properties of low-density polyethylene (LDPE)/ethylene vinyl alcohol (EVOH) (70/ 30) blends was investigated. Maleic anhydride-grafted linear low-density polyethylene (LLD-g-MAH) was used as the compatibilizer in various concentrations (from 1 to 12 phr). The interesting effect of compatibilization on the crystallization kinetics of the blends was noted, and the correlation between the morphology and the rheological and tensile properties was also discussed. Morphological analysis showed that the blends exhibited a regular and finer dispersion of the EVOH phase when LLD-g-MAH was added. Nonisothermal crystallization exotherms of the compatibilized LDPE/EVOH blends showed the retarded crystallization of the dispersed EVOH phase, which probably resulted from the constraint effect of the grafted EVOH (EVOH-g-LLD) as well as the size reduction of the EVOH domains. The blends exhibited increased melt viscosity and storage modulus and also enhanced tensile properties with the addition of LLDg-MAH, which seemed to be attributable to both dispersed particle-size reduction and improved interfacial adhesion.
π SIMILAR VOLUMES
Blends of isotactic polypropylene (iPP) with the polyamide nylon-6 (N6), prepared by extrusion, were studied with a composition of up to 30% by weight polyamide. In the case of a 70/30 iPP/N6 blend, the influence of a compatibilizing agent based on polypropylene functionalized with maleic anhydride
Blends of two polyethylenes and an elastomer were prepared to investigate the effect of the latter polymer. The blends contain equal parts of low density (LDPE) and linear low density polyethylene (LLDPE), and ethylene-propylene-diene rubber (EPDM) with variable content ranging from 0 to 17.5%. Melt
Blends consisting of high-impact polystyrene (HIPS) as the matrix and polyamide 1010 (PA1010) as the dispersed phase were prepared by mixing. The grafting copolymers of HIPS and maleic anhydride (MA), the compatibilizer precursors of the blends, were synthesized. The contents of the MA in the grafti