๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Effect of abrasive component concentration on the mechanical properties and structure of tool material prepared by electric discharge sintering

โœ Scribed by A. I. Raichenko; T. L. Istomina; G. G. Karyuk; A. A. Baidenko; M. Sh. Gol'dberg; A. F. Khrienko; A. V. Svechkov

Publisher
Springer
Year
1985
Tongue
English
Weight
542 KB
Volume
24
Category
Article
ISSN
1573-9066

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Effect of sintering temperature on the s
Effect of sintering temperature on the structure and properties of polycrystalline cubic boron nitride prepared by SPS
โœ Yucheng Zhao; Mingzhi Wang ๐Ÿ“‚ Article ๐Ÿ“… 2009 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 987 KB

were heated to a sintering temperature between 1250 โ€ข C and 1450 โ€ข C at a heating rate of 300 โ€ข C/min, with a holding time of 5 min in nitrogen atmosphere. The microstructure, phase constitution, microhardness and fracture toughness of the prepared PcBN were then studied. It was shown that the Si 3

Effects of process parameters on electri
Effects of process parameters on electrical properties of n-type Bi2Te3 prepared by mechanical alloying and spark plasma sintering
โœ L.D. Zhao; B.-P. Zhang; J.-F. Li; M. Zhou; W.S. Liu ๐Ÿ“‚ Article ๐Ÿ“… 2007 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 481 KB

n-Type Bi 2 Te 3 thermoelectric materials were prepared by spark plasma sintering (SPS) using mechanically alloyed powders. Seebeck coefficient and electrical conductivity of the resultant materials were measured, with emphasis on the effects of sintering process parameters on the electrical propert