We report the fabrication and characterization of organic photovoltaic devices using a conjugated alternating phenylenevinylene copolymer P in bulk heterojunction (BHJ) composites with PCBM. The device with copolymer P:PCBM (1:3) deposited at substrate temperature of 65 ยฐC exhibits power conversion
Effect of a buffer layer, composition and annealing on the performance of a bulk heterojunction polythiophene/fullerene composite photovoltaic device
โ Scribed by Sukhbinder Rait; Shipra Kashyap; P.K. Bhatnagar; P.C. Mathur; Sandip K. Sengupta; Jayant Kumar
- Publisher
- Elsevier Science
- Year
- 2007
- Tongue
- English
- Weight
- 652 KB
- Volume
- 39
- Category
- Article
- ISSN
- 1386-9477
No coin nor oath required. For personal study only.
โฆ Synopsis
Post-annealing of P3HT/C 60 -based plastic solar cells, composite ratio and, incorporation of a buffer layers at the ITO-polymer/ fullerene composite interface and the polymer/fullerene composite-Al interface have shown significant improvement in the performance of the photovoltaic device, both in terms of open-circuit voltage and short-circuit current. The annealing temperature, time duration and P3HT/C 60 composite ratios have been optimized for the best performance of typical ITO/PEDOT:PSS/P3HT:C 60 /LiF/Al solar cell. The C 60 content is very crucial because it improves the photocurrent in the beginning but after a certain value it leads to decrease in absorption, thereby decreasing the photocurrent.
๐ SIMILAR VOLUMES
## Abstract Herein, we address the reduction in the external quantum efficiency (EQE) of solutionโprocessed organic photodetectors caused by the room temperature phase demixing of components in the composite material of the photoactive layer. The reduction takes place under ambient conditions and a