๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Dynamic mechanical analysis of compatibilized polymer blends

โœ Scribed by J.J. Scobbo Jr


Publisher
Elsevier Science
Year
1991
Tongue
English
Weight
507 KB
Volume
10
Category
Article
ISSN
0142-9418

No coin nor oath required. For personal study only.


๐Ÿ“œ SIMILAR VOLUMES


Factor analysis for dynamic mechanical s
โœ Qiuhua Rao; Shuren Yao ๐Ÿ“‚ Article ๐Ÿ“… 1997 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 162 KB ๐Ÿ‘ 2 views

A method for studying dynamic mechanical spectroscopy (DMS) is described. By use of factor analysis, the DMS curves of twelve polyurethane/polystyrene ionomer thermoplastic interpenetrating polymer networks were studied. The isolated tan d-temperature curves of the interface region have been extract

Compatibilization of Polymer Blends
โœ Leszek A. Utracki ๐Ÿ“‚ Article ๐Ÿ“… 2002 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 213 KB
Compatibilization of PBT/polyolefin blen
โœ D. Nabi Saheb; J. P. Jog ๐Ÿ“‚ Article ๐Ÿ“… 2000 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 465 KB ๐Ÿ‘ 1 views

Blends of polybutylene terephthalate (PBT) with very lowdensity polyethylene (VLDPE) have been studied. The blends are immiscible owing to the differences in the polarities of the component polymers. Thermal studies using a differential scanning calorimeter showed that the blending does not change t

Introduction to compatibilization of pol
โœ Richard L. Markham ๐Ÿ“‚ Article ๐Ÿ“… 1990 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 575 KB

The key to preparation of commercially useful blends based on immiscible polymer pairs is compatibilization. Advances over the past ten years have considerably enhanced the understanding of this phenomenon. The selection of an appropriate compatibilizer and the processing technique to enhance the co

Blends of nylon with polyethylene: Effec
โœ Rupali Gadekar; Asmita Kulkarni; J. P. Jog ๐Ÿ“‚ Article ๐Ÿ“… 1998 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 306 KB ๐Ÿ‘ 2 views

Blends of Nylon 6 with very low density polyethylene (VLDPE) have been studied. The blends exhibit two phase morphology wherein VLDPE is dispersed in the form of spherical domains in Nylon 6 matrix. The water absorption of the blends decreased with increasing VLDPE content. The mechanical properties

Dynamic mechanical properties of isotact
โœ Snooppy George; N. R. Neelakantan; K. T. Varughese; Sabu Thomas ๐Ÿ“‚ Article ๐Ÿ“… 1997 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 742 KB

The effect of blend ratio and compatibilization on dynamic mechanical properties of PP/NBR blends was investigated at different temperatures. The storage modulus of the blend decreased with increase in rubber content and shows two T g 's indicating the incompatibility of the system. Various composit