✦ LIBER ✦

Drop size prediction in liquid membrane systems

✍ Scribed by Anshu Sharma; A.N. Goswami; B.S. Rawat

Book ID: 117511560
Publisher: Elsevier Science
Year: 1991
Tongue: English
Weight: 689 KB
Volume: 60
Category: Article
ISSN: 0376-7388
DOI: 10.1016/s0376-7388(00)81539-2

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Prediction of drop volumes in liquid–liq

Prediction of drop volumes in liquid–liquid systems

✍ John A. Izard 📂 Article 📅 1972 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 520 KB

Drop size distribution in agitated liqui

Drop size distribution in agitated liquid-liquid systems

✍ Hsiao Tsung Chen; Stanley Middleman 📂 Article 📅 1967 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 698 KB

Drop size in stirred liquid—liquid syste

Drop size in stirred liquid—liquid systems via encapsulation

✍ B.J. McCoy; A.J. Madden 📂 Article 📅 1969 🏛 Elsevier Science 🌐 English ⚖ 440 KB

Shorter Communications = 28\*12(V,)Ai -cms/sec when Pa is expressed in ems. (3) Consider now fluidised particles of average diameter 80 p and assume that the minimum bubble size the bed could sustain is 050 cm dia. From (3) above the flow rate to produce these minimum sized bubbles is 2.9 cmYsec. T

Drop sizes in an agitated liquid-liquid

Drop sizes in an agitated liquid-liquid system

✍ Youval Mlynek; William Resnick 📂 Article 📅 1972 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 906 KB

Measurements of drop size in liquid/liqu

Measurements of drop size in liquid/liquid systems by sedimentation

✍ A. Assenov; M.J. Slater 📂 Article 📅 1976 🏛 Elsevier Science 🌐 English ⚖ 699 KB

Drop size distributions in strongly coal

Drop size distributions in strongly coalescing agitated liquid-liquid systems

✍ F. B. Sprow 📂 Article 📅 1967 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 395 KB 👁 3 views

## Emulsion drop size distributions have been measured at various locations in a turbine mixer for the methyl isobutyl ketone-salt water system. The drop sizes are strongly dependent on the sampling position, being smallest near the impeller tip and largest at the bottom of the mixing tank. The va