## Abstract The thermal polymerization of methyl methacrylate is accompanied by the formation of appreciable amounts of an unsaturated dimer (H‐1). The behaviour of H‐1 during homopolymerization in presence of an initiator at 60, 80 and 100°C and during copolymerization with MMA in presence of an i
Die thermische Polymerisation von Methylmethacrylat, 1. Polymerisation in Substanz
✍ Scribed by Stickler, Manfred ;Meyerhoff, Günther
- Publisher
- Wiley (John Wiley & Sons)
- Year
- 1978
- Weight
- 860 KB
- Volume
- 179
- Category
- Article
- ISSN
- 0025-116X
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
Special purification of the monomer and careful preparation of the reaction setup allowed a thorough study of the spontaneous thermal polymerization of methyl methacrylate over a wide range of temperatures (0–140°C). The rates of polymerization are notably lower than the few data previously reported in literature, and the degrees of polymerization slightly higher. The thermal initiation reaction is superimposed by radical production due to the natural ionising radiation (cosmic radiation etc.). This additional initiation becomes significant at temperatures below 60°C. New and more reliable monomer chain transfer constants are given.
📜 SIMILAR VOLUMES
## Abstract The spontaneous thermal polymerization of methyl methacrylate (MMA) is accompanied by the production of serveral oligomers among which a linear unsaturated dimer **H‐1** (dimethyl 1‐hexene‐2,5‐dicarboxylate) is predominant. The reaction kinetics of this dimer formation was investigated
Anomalien bei der Polymerisation von Methylmethacrylat in Brombenzol wurden von BURNETT und Mitarb. l) beschrieben und als zusaitzlicher Kettenstart auf Grund einer Nebenreaktion des Initiators mit dem Brombenzol gedeutet. Es wird gezeigt, da13 diese Hypothese die experimentellen Ergebnisse nicht be
Polymerisationsgeschwindigkeit und STAUDINGERindeX verschiedener deuterierter Styrole werden mit und ohne Zusatz von Azoisobuttersauredinitril bestimmt und mit den entsprechenden Werten der nicht markierten Verbindung verglichen. Die Ergebnisse weisen darauf hin, daf3 die Wasserstoffatome in ortho-S
Die Substanzpolymerisatioii von Acrolein zu glasartigen Fornikorpern mit waBrigem Ammoniak al\_s Initiator wird beschrieben. Die chemische Reaktionsfahigkeit, das mechanisch-dynamische Verhalten, die IR-Spektren und die technologischen Eigenschaften dieser Polymerisate werden angegeben. Hieraus erge
Bei der anionischen Polymerisation von Methylmethacrylat in Athern bildet sich nicht wie im Falle des Styrols ein sogenanntes ,,lebendes Polymeres" \*). Die aktiven Enden der polymeren Anionen werden offenbar durch das Monomere selbst abgebrochen. Als moglicher Mechanismus wurde von \* ) M. SZWARC u