𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Diagnosis of failure of rolling-element bearings of alternators—a study

✍ Scribed by Har Prashad

Book ID
103480413
Publisher
Elsevier Science
Year
1996
Tongue
English
Weight
624 KB
Volume
198
Category
Article
ISSN
0043-1648

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A COMPARISON OF AUTOREGRESSIVE MODELING
A COMPARISON OF AUTOREGRESSIVE MODELING TECHNIQUES FOR FAULT DIAGNOSIS OF ROLLING ELEMENT BEARINGS
✍ D.C. Baillie; J. Mathew 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 543 KB

The paper introduces the concept of fault diagnosis using an observer bank of autoregressive time series models. The concept was applied experimentally to diagnose a number of induced faults in a rolling element bearing using the measured time series vibration signal. Three distinct techniques of au

Application of rolling element bearings
Application of rolling element bearings in centrifugal pumps
📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 416 KB

You can expect to receive long and successful operation from rolling element bearings, advises Stan SNels, but only if due attention is applied to a number of critical areas. ## R olling element (or antifriction) bearings, as applied to centrifugal pumps, have a life expectancy governed by five b

Lubrication of rolling element bearings
Lubrication of rolling element bearings with HFC–polyolester mixtures
✍ Ulf J Jonsson 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 218 KB

Manufacturers of refrigeration and air-conditioning compressors have had to re-evaluate their knowledge of compressor bearing Ž . lubrication following the introduction of hydrofluorocarbon HFC refrigerants and polyolester lubricants. The lack of anti wear protection in comparison to traditionally u

USING THE CORRELATION DIMENSION FOR VIBR
USING THE CORRELATION DIMENSION FOR VIBRATION FAULT DIAGNOSIS OF ROLLING ELEMENT BEARINGS—I. BASIC CONCEPTS
✍ David Logan; Joseph Mathew 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 427 KB

There is a wide variety of condition monitoring techniques currently in use for the diagnosis and prediction of machinery faults, but little attention has been paid to the occurrence and detection of chaotic behaviour in time series vibration signals. This paper introduces some of the basic concepts