𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Development of injection molding process by molding surface coating for heat insulation

✍ Scribed by Chikara Tanaka; Chiaki Asano; Hiraku Hayashi; Shin-ya Takimura

Publisher
Elsevier Science
Year
1999
Tongue
English
Weight
545 KB
Volume
20
Category
Article
ISSN
0389-4304

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

9732306 Development of injection molding
9732306 Development of injection molding process by molding. Surface coating for heat insulation - appearance quality improvement of injection molding parts by mold surface coating : Chikara Tanaka, Chiaki Asano, Hiraku Hayashi, Shinya Takimura (Mazda Motor Corporation)
πŸ“‚ Article πŸ“… 1998 πŸ› Elsevier Science 🌐 English βš– 138 KB

In recent years, full-shaped door trim has rapidly taken the place of flat-shaped trim. The competition for good design appearance and weight reduction has produced many processes for full-shaped door trim. We have developed a new door trim production system, the light weight reinforced-reaction inj

Experimental investigation of infrared r
Experimental investigation of infrared rapid surface heating for injection molding
✍ Pei-Chi Chang; Sheng-Jye Hwang πŸ“‚ Article πŸ“… 2006 πŸ› John Wiley and Sons 🌐 English βš– 395 KB πŸ‘ 2 views

## Abstract A low cost and practical infrared rapid surface heating system for injection molding is designed and investigated. The system was designed to assemble on the mold and a control system was used to operate the motion of the lamp holder. Four infrared halogen lamps (1 kW each) were used as

Using thermally insulated polymer film f
Using thermally insulated polymer film for mold temperature control to improve surface quality of microcellular injection molded parts
✍ Hui-Li Chen; Rean-Der Chien; Shia-Chung Chen πŸ“‚ Article πŸ“… 2008 πŸ› Elsevier Science 🌐 English βš– 393 KB

Microcellular injection molding provides many advantages over conventional foams and their unfoamed counterparts, but its applications are limited by visible surface quality problems such as silver streaks and swirl marks. In this study, a mold temperature control method was proposed which a thermal

A review of current developments in proc
A review of current developments in process and quality control for injection molding
✍ Zhongbao Chen; Lih-Sheng Turng πŸ“‚ Article πŸ“… 2005 πŸ› John Wiley and Sons 🌐 English βš– 181 KB πŸ‘ 1 views

## Abstract Injection molding is one of the most versatile and important manufacturing processes capable of mass‐producing complicated plastic parts in net shape with excellent dimensional tolerance. Injection molding process and quality control has been an active research area for many years, as p

Development of a test method for the rhe
Development of a test method for the rheological characterization of polymers under the injection molding process conditions
✍ P.F. Bariani; M. Salvador; G. Lucchetta πŸ“‚ Article πŸ“… 2007 πŸ› Elsevier Science 🌐 English βš– 242 KB

The reliability of numerical simulations of the injection molding process depends mainly on the rheological characteristics of polymers. The rheological characterization of a polymer for injection molding is commonly carried out by a capillary rheometer. However, in this method the measurement is ca