๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Development of flashing flow model for box type orifice

โœ Scribed by M. Kishi; Y. Mochizuki; M. Matsubayashi; K. Hattori

Publisher
Elsevier Science
Year
1987
Tongue
English
Weight
265 KB
Volume
65
Category
Article
ISSN
0011-9164

No coin nor oath required. For personal study only.

โœฆ Synopsis

To stabilize water level in flash evaporators, flashing model is discussed and a flow model of two phase flashing flow is established. This model is applied to the flow in the box type orifice, in qood accordance with the calculated results and the experjmental data. A-parameter survey of water level in actual plant shows the water level control may be stable.

๐Ÿ“œ SIMILAR VOLUMES

Development of flow model for weir type
Development of flow model for weir type orifice
โœ M. Kishi; K. Matsumoto; Y. Takeuchi; K. Hattori ๐Ÿ“‚ Article ๐Ÿ“… 1985 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 269 KB

The weir type orifice is widely used as an interstage sealing device of an MSF evaporator and as a flow regulating device of brine and distillate flows. The existing flow model for a weir type orifice is described simply as an orifice without any consideration to weir hydraulic characteristics. Th

Evaluation of two-phase flow models for
Evaluation of two-phase flow models for flashing flow in nozzles
โœ Ron Darby ๐Ÿ“‚ Article ๐Ÿ“… 2000 ๐Ÿ› American Institute of Chemical Engineers ๐ŸŒ English โš– 584 KB

## Abstract A variety of methods and models have been proposed in the literature for sizing relief valves for twoโ€phase flow applications. A typical application involves liquids which flash during discharge as the pressure drops. The predictions from these various methods can vary greatly under suc

Development of a chip flow model for tur
Development of a chip flow model for turning operations
โœ J. Wang ๐Ÿ“‚ Article ๐Ÿ“… 2001 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 104 KB

A model is presented which predicts the chip flow direction in turning operations with nose radius tools under oblique cutting conditions. Only the tool cutting edge geometry and the cutting conditions (feed and depth of cut) are required to implement the model. An experimental study has verified th