✦ LIBER ✦

Development of fast algorithms for estimating stress corrosion crack growth rate

✍ Scribed by G.R. Engelhardt; D.D. Macdonald; M. Urquidi-Macdonald

Book ID: 117087528
Publisher: Elsevier Science
Year: 1999
Tongue: English
Weight: 337 KB
Volume: 41
Category: Article
ISSN: 0010-938X
DOI: 10.1016/s0010-938x(99)00058-x

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Response to Dr. A. Turnbull's discussion

Response to Dr. A. Turnbull's discussion on “Development of fast algorithms for estimating stress corrosion crack growth rate”: [Corrosion Science 41 (12) (1999) 2267]

✍ G.R Engelhardt; D.D Macdonald; M Urquidi-Macdonald 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 60 KB

Discussion on “Development of fast algor

Discussion on “Development of fast algorithms for estimating stress corrosion crack growth rate” by G.R. Engelhardt, D.D. Macdonald and M. Urquidi-Macdonald [Corrosion Science 41 (12) (1999) 2267]

✍ Alan Turnbull 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 39 KB

Predicting the growth rate of a three-di

Predicting the growth rate of a three-dimensional stress corrosion crack

✍ E. Smith 📂 Article 📅 1985 🏛 Springer Netherlands 🌐 English ⚖ 448 KB

The estimation of creep crack growth rat

The estimation of creep crack growth rates by reference stress methods

✍ B. L. Freeman 📂 Article 📅 1979 🏛 Springer Netherlands 🌐 English ⚖ 575 KB

Investigation of stress corrosion crack

Investigation of stress corrosion crack growth in Mg alloys using J-integral estimations

✍ Abramson, G. ;Evans, J. T. ;Parkins, R. N. 📂 Article 📅 1985 🏛 The Minerals, Metals & Materials Society 🌐 English ⚖ 944 KB

Determination of corrosion-assisted stre

Determination of corrosion-assisted stress crack growth rate in 304L stainless steel welds

✍ A. Díaz-Sánchez; V. M. Castaño 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 German ⚖ 209 KB 👁 1 views

The corrosion assisted stress crack growth rate of 304L stainless steel welds, was determined by the rising displacement test method. The experiments were carried out in a Boiling Water Reactor (BWR) environment, using a refreshed autoclave loop system at 288 C and 8 MPa of pressure. Pre-fatigued CT