✦ LIBER ✦

Development of an aerodynamic levitation technique to study coal particle combustion

✍ Scribed by Robert E. Peck; Michael A. Pollock

Book ID: 107755692
Publisher: Elsevier Science
Year: 1981
Tongue: English
Weight: 709 KB
Volume: 60
Category: Article
ISSN: 0016-2361
DOI: 10.1016/0016-2361(81)90227-1

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

An axial viewing photographic technique

An axial viewing photographic technique to study turbulence characteristics of particles

✍ M.M. Lee; T.J. Hanratty; R.J. Adrian 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 1002 KB

Development of an ultracentrifuge techni

Development of an ultracentrifuge technique to determine the adhesion and friction properties between particles and surfaces

✍ Fridrun Podczeck; J. Michael Newton 📂 Article 📅 1995 🏛 John Wiley and Sons 🌐 English ⚖ 660 KB

Universal wet-milling technique to prepa

Universal wet-milling technique to prepare oral nanosuspension focused on discovery and preclinical animal studies – Development of particle design method

✍ Toshiyuki Niwa; Satoru Miura; Kazumi Danjo 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 813 KB

99/01635 Methodology development to dete

99/01635 Methodology development to determine fine particle characteristics of coal combustion emissions : Lee, S. W. et al. EC (Am. Soc. Mech. Eng.), 1997, 5, (1), 97–103

📂 Article 📅 1999 🏛 Elsevier Science ⚖ 224 KB

Environment (pollution, health protection, safety) controller, slurrying the fly ashes with seawater at controlled amounts, storing the slurry formed in a temporary storage tank and transporting the slurry by a slurry transport pump to an ash-dumping ground.

Study of the correlation between surface

Study of the correlation between surface roughness and cutting vibrations to develop an on-line roughness measuring technique in hard turning

✍ Dong Young Jang; Young-Gu Choi; Hong-Gil Kim; Alex Hsiao 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 733 KB

Surface roughness is one of the important factors in all areas of tribology and in evaluating the quality of a machining operation. In order to achieve computer controlled machining in a flexible manufacturing system, a technique is needed for the on-line, real-time monitoring of each machining proc