✦ LIBER ✦

Determination of the frequencies of precessional vibrations of a double-rotor gyroscopic device on a torsional suspension

✍ Scribed by A. Yu. Dmitriev; A. N. Nikitin; I. V. Nikolenko; V. A. Pyatetskii; S. P. Sosnitskii

Publisher: Springer US
Year: 1977
Tongue: English
Weight: 281 KB
Volume: 13
Category: Article
ISSN: 1573-8582
DOI: 10.1007/bf00901810

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Influence of linear depth taper on the f

Influence of linear depth taper on the frequencies of free torsional vibration of a cantilever beam

✍ M.Amir Ali; M.Ananda Rao; M.K.K. Elisha 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 340 KB

On the autonomous determination of posit

On the autonomous determination of position of a moving object by means of a space gyrocompass, a directional gyroscope and an integrating device

✍ A.Iu. Ishlinskii 📂 Article 📅 1959 🏛 Elsevier Science 🌐 English ⚖ 532 KB

Use of the double-channel method to decr

Use of the double-channel method to decrease the effect of outside interferences on the drift of a three-stage gyroscope in a universal suspension [gimbals]

✍ A. A. Odintsov 📂 Article 📅 1974 🏛 Springer US 🌐 English ⚖ 531 KB

Determination of the Self-Excite Vibrati

Determination of the Self-Excite Vibration Amplitude of a Rigid Rotor Supported on n-lobe Journal Bearing

✍ A. Lasocki; Z. Starczewski 📂 Article 📅 2002 🏛 John Wiley and Sons ⚖ 77 KB

ON THE APPROXIMATE DETERMINATION OF THE

ON THE APPROXIMATE DETERMINATION OF THE FUNDAMENTAL FREQUENCY OF VIBRATION OF RECTANGULAR, ANISOTROPIC PLATES CARRYING A CONCENTRATED MASS

✍ R.O. Grossi; L. Nallim 📂 Article 📅 1997 🏛 Elsevier Science 🌐 English ⚖ 117 KB

A note on the determination of the funda

A note on the determination of the fundamental frequency of vibration of a rectangular plate with a free, semicircular cut-out along the edge

✍ P.A.A. Laura; L. Ercoli; J. Baron; G. Sanchez Sarmiento; J.C. Utjes 📂 Article 📅 1986 🏛 Elsevier Science 🌐 English ⚖ 940 KB

The title problem is tackled by using polynomial co-ordinate functions and the Ritz method in order to generate an approximate frequency equation. It is shown that in the case of a clamped square plate the results are in good engineering agreement with frequency values obtained by means of the finit