✦ LIBER ✦

Design support to determine the range of design parameters by qualitative reasoning

✍ Scribed by Ohki, M.; Shinjo, H.; Oohira, E.; Abe, M.

Book ID: 114550544
Publisher: Institute of Electrical and Electronics Engineers
Year: 1994
Weight: 850 KB
Volume: 24
Category: Article
ISSN: 0018-9472
DOI: 10.1109/21.293499

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The Design of a New Policy Model to Supp

The Design of a New Policy Model to Support Ontology-Driven Reasoning for Autonomic Networking

✍ John Strassner; José Neuman de Souza; Sven van der Meer; Steven Davy; Keara Barr 📂 Article 📅 2009 🏛 Springer US 🌐 English ⚖ 639 KB

Determination of the parameters of distu

Determination of the parameters of disturbed zones when designing the support of underground hydraulic structures

✍ N. S. Chetyrkin; V. I. Sheinin; É. F. Rikkert; V. M. Benenson; M. G. Bikineev; M 📂 Article 📅 1986 🏛 Springer 🌐 English ⚖ 469 KB

Fuzzy decision-making model to determine

Fuzzy decision-making model to determine the parameters for intelligent design of power system protection

✍ Liu, L.F.; Gao, Z.D.; Yang, Q.X.; Liu, B.Z. 📂 Article 📅 1998 🏛 The Institution of Electrical Engineers 🌐 English ⚖ 590 KB

The Design of a Knowledge-Based Decision

The Design of a Knowledge-Based Decision Support System to Support the Information Analyst in Determining Requirements

✍ Nikunj P. Dalal; Surya B. Yadav 📂 Article 📅 1992 🏛 Decision Sciences Institute, Georgia State Univers 🌐 English ⚖ 979 KB

Design support based on projection of in

Design support based on projection of information across the product-development life cycle by means of case-based reasoning

✍ Irgens, C.S. 📂 Article 📅 1995 🏛 The Institution of Electrical Engineers 🌐 English ⚖ 460 KB

Using back analysis to estimate geotechn

Using back analysis to estimate geotechnical field parameters for the design of support systems for tunnels

✍ B.Z. Amusin; V.M. Shick; R.D. Lama 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 333 KB

A simple method for the estimation of geotechnical field parameters for the design of support system for tunnels is described. The method is based upon back analysis of a limited amount of deformation measurements in a pilot or prototype tunnel using the theoretical~empirical approach developed at