✦ LIBER ✦

Design and manufacturing advisor for turbine disks

✍ Scribed by Steven H. Kim; Stephen Hom; Sanjay Parthasarathy

Book ID: 103913394
Publisher: Elsevier Science
Year: 1988
Tongue: English
Weight: 618 KB
Volume: 4
Category: Article
ISSN: 0736-5845
DOI: 10.1016/0736-5845(88)90030-0

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Designs of drums and disks for rotors of

Designs of drums and disks for rotors of steam turbines

📂 Article 📅 1913 🏛 Elsevier Science 🌐 English ⚖ 141 KB

Design of support structures for offshor

Design of support structures for offshore wind turbines – Interfaces between project owner, turbine manufacturer, authorities and designer

✍ Marc Seidel 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 German ⚖ 687 KB

## Abstract Design of support structures for offshore wind turbines is a challenging subject both technically and logistically. Many stakeholders are involved in this process, which have many technical and commercial interfaces. Managing these interfaces can involve special technical approaches and

A manufacturability advisor for spun and

A manufacturability advisor for spun and rollformed sheet metal components

✍ K.V. Ramana; Manvinder Singh; Abhishek Gupta; Rohit Dey; Ankur Kapoor; P.V.M. Ra 📂 Article 📅 2005 🏛 Springer 🌐 English ⚖ 443 KB

Design and experimental studies of low-c

Design and experimental studies of low-cycle fatigue defects in turbine disks of aircraft long-life gas turbine engines

✍ N. P. Velikanova; L. R. Botvina; G. P. Okatova 📂 Article 📅 2008 🏛 Allerton Press, Inc. 🌐 English ⚖ 250 KB

Disk drive flat optics: design factors a

Disk drive flat optics: design factors affecting manufacturing and cost in volume

✍ Westney, Ronald P. ;Swaby, Basil L. 📂 Article 📅 1988 🏛 The Optical Society 🌐 English ⚖ 454 KB

Design for manufacturability and yield

✍ Andrzej J. Strojwas 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 693 KB