Deformation and fracture of urethane–methacrylate resins

✍ Scribed by R. H. Elleithy; A. Hiltner; E. Baer; I. M. Fraser; M. L. Orton

• Publisher: John Wiley and Sons
• Year: 1995
• Tongue: English
• Weight: 848 KB
• Volume: 55
• Category: Article
• ISSN: 0021-8995
• DOI: 10.1002/app.1995.070551004

✦ Synopsis

The tensile properties of three urethane-methacrylate resins that varied in the soft segment content of the urethane were characterized. The strain birefringence at a circular hole was observed during loading-unloading cycles to progressively higher displacements. The shear strain distribution at the hole was calculated from the isochromatic fringe contours and compared with results from linear elastic analysis. When the onset of nonlinearity, and the subsequent appearance of residual strain at the root of the hole, were correlated with features of the macroscopic stress-displacement curves, three regions of prefracture deformation were defined. A region of linear elastic behavior was observed at the lowest strains. The maximum shear strain at the linear limit was the same in all the resins, and appeared to correlate with the yield condition at the hole. When the shear strain at the hole exceeded about 2.8%, the fringe patterns started to deviate from the elastic prediction. However, strain was fully recoverable in this region as indicated by the absence of residual birefringence at the hole after unloading. This region of nonlinear, recoverable deformation extended to progressively higher strains as the amount of urethane soft segment increased. This feature was attributed to the network structure of the urethane-methacrylate resins. A region characterized by nonrecoverable deformation at the hole followed at higher strains; the urethane soft segment content had a major effect on the amount of permanent deformation sustained before fracture. The fracture surfaces exhibited features typical of brittle fracture without crazing.