𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Deformation and fracture behaviour of flax fibre reinforced thermosetting polymer matrix composites

✍ Scribed by Mark Hughes; James Carpenter; Callum Hill


Publisher
Springer
Year
2007
Tongue
English
Weight
612 KB
Volume
42
Category
Article
ISSN
0022-2461

No coin nor oath required. For personal study only.


πŸ“œ SIMILAR VOLUMES


Fracture behaviour of SiC fibre-reinforc
✍ E. Zhang; D. P. Thompson πŸ“‚ Article πŸ“… 1996 πŸ› Springer 🌐 English βš– 948 KB

Both Nicalon and Hi-Nicalon SiC fibre-reinforced nitrogen glass composites were prepared by slurry infiltration and hot-pressing, and the interfacial features, fracture behaviour and mechanical properties of these composites were investigated. It was found that the interfacial characteristics were m

Creep and creep-fatigue behaviour of con
✍ B. Eng. G. West; Dr.-Ing. A. R. Boccaccini; Prof. Dr. D. M. R. Taplin πŸ“‚ Article πŸ“… 1995 πŸ› John Wiley and Sons 🌐 English βš– 688 KB

## Abstract The flexural creep and creep strain recovery behaviour during creep‐fatigue tests of a cross‐ply SiC fibre reinforced Barium Magnesium Aluminosilicate glass‐ceramic matrix composite was investigated at 1100Β°C in air. Only heat‐treated samples (1 h at 1100Β°C) were tested. Stress levels o

Fracture mechanisms of the fiber/matrix
✍ Robert A. Latour Jr.; Jonathan Black; Bernard Miller πŸ“‚ Article πŸ“… 1991 πŸ› John Wiley and Sons 🌐 English βš– 941 KB

## Abstract The fracture behavior of the fiber/matrix interfacial bond is an important governing factor of both composite fracture behavior and its environmental resistance. Methods have been developed to investigate the ultimate and dynamic fatigue fracture behavior of the interfacial bond in both

On the mechanical properties, deformatio
✍ A.C.N. Singleton; C.A. Baillie; P.W.R. Beaumont; T. Peijs πŸ“‚ Article πŸ“… 2003 πŸ› Elsevier Science 🌐 English βš– 576 KB

A composite laminate based on natural flax fibre and recycled high density polyethylene was manufactured by a hand lay-up and compression moulding technique. The mechanical properties of the composite were assessed under tensile and impact loading. Changes in the stress -strain characteristics, of y