✦ LIBER ✦

Cutting performance of nanocomposite Cr–C–N, Cr–Si–N and Cr–Si–C–N coated tools for micro end-milling operation

✍ Scribed by M.W. Kim; H.S. Tak; M.C. Kang; K.H. Kim; I.D. Park; T.J. Je

Book ID: 108079195
Publisher: Elsevier Science
Year: 2009
Tongue: English
Weight: 551 KB
Volume: 9
Category: Article
ISSN: 1567-1739
DOI: 10.1016/j.cap.2008.12.061

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Nanostructured Ti-Cr-B-N and Ti-Cr-Si-C-

Nanostructured Ti-Cr-B-N and Ti-Cr-Si-C-N coatings for hard-alloy cutting tools

✍ F. V. Kiryukhantsev-Korneev; A. N. Sheveiko; V. A. Komarov; M. S. Blanter; E. A. 📂 Article 📅 2011 🏛 Allerton Press, Inc. 🌐 English ⚖ 597 KB

Cutting performance of CrN and Cr-Si–N c

Cutting performance of CrN and Cr-Si–N coated end-mill deposited by hybrid coating system for ultra-high speed micro machining

✍ S.H. Shin; M.W. Kim; M.C. Kang; K.H. Kim; D.H. Kwon; J.S. Kim 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 602 KB

## Hybrid coating system Cr-Si-N coatings Micro end-milling Ultra-high speed machining Tool performance In this paper, comparative studies on the properties and cutting performance between CrN and Cr-Si-N coated micro end-mill for ultra-high speed machining applications were conducted. Ternary Cr-S

Mechanical properties and cutting perfor

Mechanical properties and cutting performance of Cr–Al–N hybrid coated micro-tool for micro high-speed machining of flexible fine die

✍ Kim, M.W.; Kim, K.H.; Kang, M.C.; Cho, S.H.; Ryu, K.T. 📂 Article 📅 2012 🏛 Elsevier Science 🌐 English ⚖ 622 KB