✦ LIBER ✦

Cutting force model for a small-diameter helical milling cutter

✍ Scribed by Li, Xiwen ;Yang, Mingjin ;Xie, Shouyong ;Yang, Shuzi

Book ID: 107378232
Publisher: Higher Education Press and Springer
Year: 2007
Tongue: English
Weight: 547 KB
Volume: 2
Category: Article
ISSN: 1673-3479
DOI: 10.1007/s11465-007-0047-1

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A Cutting Force Model for a Waved-Edge E

A Cutting Force Model for a Waved-Edge End Milling Cutter

✍ B. Zhang; L. Zheng; Z. Zhang; L. Zhang; Z. Li; D. Liu 📂 Article 📅 2003 🏛 Springer 🌐 English ⚖ 183 KB

Theoretical modelling of cutting forces

Theoretical modelling of cutting forces in helical end milling with cutter runout

✍ X.P. Li; H.Z. Li 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 343 KB

A Cutting Force Model for Face Milling O

A Cutting Force Model for Face Milling Operation

✍ Tang, Dong Hong; Lu, Fang 📂 Article 📅 2013 🏛 Trans Tech Publications, Ltd. 🌐 English ⚖ 300 KB

Dynamic Force Modelling for a Ball-End M

Dynamic Force Modelling for a Ball-End Milling Cutter Based on the Merchant Oblique Cutting Theory

✍ Shui-Jin Li; Yun-Fei Zhou; Ren-Cheng Jin; Zhou Ji 📂 Article 📅 2001 🏛 Springer 🌐 English ⚖ 189 KB

Dynamic behaviour improvement for a toru

Dynamic behaviour improvement for a torus milling cutter using balance of the transversal cutting force

✍ Patrick Gilles; Guillaume Cohen; Frederic Monies; Walter Rubio 📂 Article 📅 2008 🏛 Springer 🌐 English ⚖ 244 KB

Modelling of cutting forces in helical e

Modelling of cutting forces in helical end milling using a predictive machining theory

✍ H.Z. Li; W.B. Zhang; X.P. Li 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 742 KB

A new approach for modelling and simulation of the cutting forces in helical end milling processes is presented. In this approach, the cutting forces in helical end milling are modelled based on a predictive machining theory, in which the machining characteristic factors are predicted from input dat