✦ LIBER ✦

Cutting conditions in deep diamond grinding of aluminum alloys

✍ Scribed by A. N. Senichev; V. N. Kiselev; A. S. Yamnikov

Book ID: 111510130
Publisher: Allerton Press, Inc.
Year: 2011
Tongue: English
Weight: 134 KB
Volume: 31
Category: Article
ISSN: 1068-798X
DOI: 10.3103/s1068798x11050194

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Experimental Investigation of Electrical

Experimental Investigation of Electrical Discharge Diamond Cut-Off Grinding of Ti Alloy

✍ Yadav, Sanjeev Kumar Singh; Yadava, Vinod 📂 Article 📅 2013 🏛 Taylor and Francis Group 🌐 English ⚖ 604 KB

Diamond abrasive grinding of pump piston

Diamond abrasive grinding of pump pistons: Costs and conditions for finish cuts

✍ B. B. Trinchuk; D. E. Anel'chik 📂 Article 📅 1967 🏛 Springer 🌐 English ⚖ 204 KB

Effect of diamond surface grinding condi

Effect of diamond surface grinding conditions on the strength of hard alloys

✍ V. N. Bakul; M. G. Loshak; L. V. Chaika 📂 Article 📅 1968 🏛 Springer 🌐 English ⚖ 242 KB

Development of DLC Coated Tool for Cutti

Development of DLC Coated Tool for Cutting of Aluminum Alloy －Influence of Deposition Condition on Cutting Characteristic－

✍ Minaki, Kazushi; Kitajima, Koichi; Nakahira, Yu; Ohnishi, Masami; Sugimoto, Taka 📂 Article 📅 2008 🏛 Trans Tech Publications, Ltd. 🌐 English ⚖ 391 KB

The assessment of the grinding wheel cut

The assessment of the grinding wheel cutting surface condition after dressing with the single point diamond dresser

✍ Andrzej Koziarski; Andrze Goła̧bczak 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 774 KB

Wear behavior of natural diamond tool in

Wear behavior of natural diamond tool in cutting tungsten-based alloy

✍ Yuanliang Zhang, Zhimin Zhou, Yan Lv… 📂 Article 📅 2013 🏛 Springer 🌐 English ⚖ 458 KB