𝔖 Bobbio Scriptorium
✦   LIBER   ✦

“CUT AND SPLICE”—A METHOD OF WEIGHT ESTIMATING FOR REPEAT SHIP DESIGN

✍ Scribed by GREGORY J. BURCH

Book ID
114771600
Publisher
American Society of Naval Engineers
Year
1984
Tongue
English
Weight
876 KB
Volume
96
Category
Article
ISSN
0028-1425

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A simple method for estimating the splic
A simple method for estimating the splice loss of photonic-crystal fiber/single-mode fiber
✍ J. Ju; W. Jin; Y. L. Hoo; M. S. Demokan 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 206 KB

## Abstract A simple formula for calculating the mode‐field diameter of large‐mode‐area endlessly single‐mode photonic‐crystal fiber (PCF) is obtained and used to estimate the splice loss of PCF/single‐mode fiber. The accuracy of splice‐loss estimation is less than 0.2 dB. © 2004 Wiley Periodicals,

A method for estimating unperturbed chai
A method for estimating unperturbed chain dimension from molecular weight dependence of sedimentation and diffusion coefficients
✍ K. Kamide; M. Saito 📂 Article 📅 1982 🏛 Elsevier Science 🌐 English ⚖ 319 KB

AMtraet--A method tmethod 2L) has been proposed for evaluation of the unperturbed chain dimension A from the molecular weight dependence of the molecular friction coe~cient, derived from sedimentation and ditl'usion coefficients. This method is widely applicable when the unperturbed chain is non-Gau

A method for estimating bulk melt temper
A method for estimating bulk melt temperature and part weight in injection molding of amorphous thermoplastics
✍ A. E. Varela; M. R. Kamal; W. I. Patterson 📂 Article 📅 1996 🏛 John Wiley and Sons 🌐 English ⚖ 730 KB

A methodology is presented to estimate cavity melt temperatures and part weight in the injection molding of amorphous thermoplastics. The approach uses measurements of cavity pressure near the gate and surface temperatures at three sensor locations. The surface temperature data with a heat conductio