Coupled heat and mass transfer in a packed bed with the lewis relation not satisfied
โ Scribed by D.J. Close; P.J. Banks
- Publisher
- Elsevier Science
- Year
- 1974
- Tongue
- English
- Weight
- 739 KB
- Volume
- 29
- Category
- Article
- ISSN
- 0009-2509
No coin nor oath required. For personal study only.
โฆ Synopsis
This paper forms part of the development of an analogy between heat transfer and coupled heat and mass transfer. It has been shown that for a particular case of coupled heat and mass transfer between a packed sorbent bed and the fluid flowing through, the linearised governing equations have the same form as those for heat transfer alone in the system. In that case transport of heat and sorbate between the fluid mixture and sorbent was determined by surface transfer coefficients, and the Lewis relation between these coefficients was satisfied.
The Lewis relation is far from satisfied for many fluid mixtures, and when lumped transfer coefficients are employed to account for diffusion in the sorbent. The effect of such departures on system behaviour is explored by a numerical method. Also, the above analogy method is extended to deal with such systems. Comparison of results from these two methods shows that the extended analogy method gives a fairly close representation of the system behaviour resulting from a step change in the inlet fluid state.
๐ SIMILAR VOLUMES
The possibility of producing cold heat energy by a super active carbon/ethanol adsorption heat pump (AHP) with a packed bed type adsorber is discussed on the basis of both experimental and calculated results of the transient behavior accompanied by this operation. The trend in experimental results
The pressure drop per umt length m flow through packed beds or past turbulence promoters IS the sum of viscous and kmetlc losses 5 = a@+ bpV2 The transfer rates m such systems (dependent only on the VISCOUS forces at the transfer surfaces) are correlated by -112 = K [Re\*]-"e and may therefore be p
Ah&act-Simultaneous heat and mass transfer, which arises from injecting a gas into a flowing external stream, has been studied analytically for a flat plate geometry. The studies are centered around the effect of free stream concentration of the injected gas on the thermodynamic coupling, over a wid