✦ LIBER ✦

Corrosion characteristic of Ce Al brass in comparison with As Al brass

✍ Scribed by J.L. Chen; Z. Li; Y.Y. Zhao

Publisher: Elsevier Science
Year: 2009
Weight: 617 KB
Volume: 30
Category: Article
ISSN: 0261-3069
DOI: 10.1016/j.matdes.2008.07.041

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Corrosion Behaviour of brass in nitric a

Corrosion Behaviour of brass in nitric acid solutions

✍ Dr. A. A. Al-Suhybani; A. A. Hazza; M. Al-Mishary 📂 Article 📅 1992 🏛 John Wiley and Sons 🌐 English ⚖ 648 KB

## Abstract The corrosion of Brass in nitric acid solutions is studied using thermometric, mass loss and polarization methods. The three methods gave almost similar results. The rate of corrosion was found to increase steadily with nitric acid concentration till about 9M where it starts to slow dow

Surface treatment of Cf/Al composites wi

Surface treatment of Cf/Al composites with immersion in aqueous solution containing Ce ions for corrosion barrier

✍ C. Wang; G. Chen; G. Wu 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 German ⚖ 597 KB

## Abstract In this study, Ce‐rich coating is investigated as corrosion inhibitor of carbon fibers reinforcement aluminum matrix (Cf/Al) composites. The coatings are obtained by immersion in aqueous solution containing Ce(NO~3~)~3~ onto composite surface, whereas the Ce‐rich coating process produce

Corrosion characteristics of Al-Si-Mg/Si

Corrosion characteristics of Al-Si-Mg/SiCp composites with varying Si/Mg molar ratio in neutral chloride solutions

✍ R. Escalera-Lozano; M. A. Pech-Canul; M. I. Pech-Canul; P. Quintana 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 German ⚖ 493 KB

## Abstract The corrosion resistance of Al‐Mg‐Si/SiC~p~ composites produced by the pressureless infiltration method [using SiC~p~ preforms with 50% porosity containing rice hull ash (RHA) and four custom‐made alloys with varying Si/Mg molar ratio] was evaluated in neutral 0.1 M NaCl solutions. The

Evaluation of the biomass “date stones”

Evaluation of the biomass “date stones” as a fuel in furnaces: A comparison with coal combustion

✍ S.-A.B. Al-Omari 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 466 KB

The present investigation gives insight into the potential of the biomass fuel "date stones" as an energy source for furnaces. This is accomplished by comparing combustion and heat transfer characteristics obtained in a furnace fueled with both fuels: date stones and a type of coal. The analysis of

Holographic interferometry as electroche

Holographic interferometry as electrochemical emission spectroscopy of carbon steel in seawater with low concentration of RA-41 corrosion inhibitor

✍ K. Habib; K. Al-Muhana; A. Habib 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 447 KB

In the present investigation, holographic interferometry was utilized for the first time to determine the rate change of the number of the fringe evolutions during the corrosion test of carbon steel in blank seawater and with seawater with different concentrations of a corrosion inhibitor. In other