✦ LIBER ✦

Computing masses and surface tension from effective transfer matrices

✍ Scribed by M. Hasenbusch; K. Rummukainen; K. Pinn

Book ID: 113393045
Publisher: Elsevier Science
Year: 1994
Tongue: English
Weight: 207 KB
Volume: 34
Category: Article
ISSN: 0920-5632
DOI: 10.1016/0920-5632(94)90364-6

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Surface-tension-induced interfacial conv

Surface-tension-induced interfacial convection and its effect on rates of mass transfer

✍ Dr. Henryk Sawistowski 📂 Article 📅 1973 🏛 John Wiley and Sons 🌐 German ⚖ 661 KB

Surface Tension Effects and Enhancement

Surface Tension Effects and Enhancement of Condensation Heat Transfer

✍ J.W. Rose 📂 Article 📅 2004 🏛 Institution of Chemical Engineers 🌐 English ⚖ 608 KB

Turbulent heat and mass transfer from ro

Turbulent heat and mass transfer from rough surfaces

✍ G. A. Hughmark 📂 Article 📅 1972 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 141 KB 👁 2 views

Effectiveness of mass transfer in a pack

Effectiveness of mass transfer in a packed distillation column in relation to surface tension gradients

✍ W.B. Patberg; A. Koers; W.D.E. Steenge; A.A.H. Drinkenburg 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 582 KB

## Ah&act -In packed columns large differences occur in the wetting of the particles and especially in the refreshing of the liquid 011 the wetted particles due to gradients in surface tension of the liquid/gas interface. Mass transfer rates may die, with a factor 2. In a column packed with Berl s

Effect of interfacial velocity and inter

Effect of interfacial velocity and interfacial tension gradient on momentum, heat and mass transfer

✍ Akira Hirata; Madoka Kawakami; Yasunori Okano 📂 Article 📅 1989 🏛 John Wiley and Sons 🌐 English ⚖ 784 KB

The effect of surface active agents on m

The effect of surface active agents on mass transfer from spherical cap bubbles

✍ M.E. Weber 📂 Article 📅 1975 🏛 Elsevier Science 🌐 English ⚖ 376 KB

The influence of surface active agents on the rate of dissolution of spherical cap bubbles at Re > 100 is modeled by assuming that the surfactant forms a stagnant film on the spherical surface near the rim of the bubble. The extent of this stagnant zone is dictated by a balance between surface force