✦ LIBER ✦

Comprehensive analysis of joint strength for dissimilar friction stir welds of mild steel to aluminum alloys

✍ Scribed by Tsutomu Tanaka; Taiki Morishige; Tomotake Hirata

Book ID: 113898022
Publisher: Elsevier Science
Year: 2009
Tongue: English
Weight: 239 KB
Volume: 61
Category: Article
ISSN: 1359-6462
DOI: 10.1016/j.scriptamat.2009.06.022

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Optimization of friction stir welding pa

Optimization of friction stir welding parameters for dissimilar aluminum alloys

✍ M. Ghosh; K. Kumar; S.V. Kailas; A.K. Ray 📂 Article 📅 2010 🏛 Elsevier Science ⚖ 863 KB

On the Critical Technological Issues of

On the Critical Technological Issues of Friction Stir Welding T-Joints of Dissimilar Aluminum Alloys

✍ A. Astarita, A. Squillace, A. Scala, A. Prisco 📂 Article 📅 2011 🏛 Springer US 🌐 English ⚖ 818 KB

Friction stir welding of mild steel to a

Friction stir welding of mild steel to alloy 625 – development of welding parameters

✍ Rodriguez, J.; Ramirez, A. J. 📂 Article 📅 2014 🏛 Maney Publishing 🌐 English ⚖ 408 KB

Optimizing friction stir welding paramet

Optimizing friction stir welding parameters to maximize tensile strength of AA2219 aluminum alloy joints

✍ S. Babu; K. Elangovan; V. Balasubramanian; M. Balasubramanian 📂 Article 📅 2009 🏛 TechnoPress 🌐 English ⚖ 792 KB

Polishing-assisted galvanic corrosion in

Polishing-assisted galvanic corrosion in the dissimilar friction stir welded joint of AZ31 magnesium alloy to 2024 aluminum alloy

✍ C. Liu; D.L. Chen; S. Bhole; X. Cao; M. Jahazi 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 633 KB

Evaluation of fatigue strength of fricti

Evaluation of fatigue strength of friction stir butt-welded aluminum alloy joints inclined to applied cyclic stress

✍ Shigenobu Kainuma; Hiroto Katsuki; Ichiro Iwai; Masaki Kumagai 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 839 KB

Recently, fatigue tests have been performed to investigate the fatigue behavior of friction stir butt-welded aluminum alloy joints. However, the joints of more than 10 mm thick plates have rarely been tested, nor has the effect of the inclined angle of the friction stir welding line to the applied s