✦ LIBER ✦

Compositional effects on the mechanochemical synthesis of Fe–Ti and Cu–Ti amorphous alloys by mechanical alloying

✍ Scribed by F. Delogu; G. Cocco

Book ID: 117621423
Publisher: Elsevier Science
Year: 2003
Tongue: English
Weight: 535 KB
Volume: 352
Category: Article
ISSN: 0925-8388
DOI: 10.1016/s0925-8388(02)01109-x

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Fabrication of Ti–Cu–Ni–Al amorphous all

Fabrication of Ti–Cu–Ni–Al amorphous alloys by mechanical alloying and mechanical milling

✍ Hiroaki Kishimura; Hitoshi Matsumoto 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 995 KB

Synthesis of NiTi and FeTi alloys by m

Synthesis of NiTi and FeTi alloys by mechanical alloying: formation of amorphous phases and extended solid solutions

✍ J. Eckert; L. Schultz; K. Urban 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 519 KB

Effects of Ti-replacing on the crystalli

Effects of Ti-replacing on the crystallization mechanism of amorphous Zr–Ti–Al–Cu–Ni alloys

✍ S.J. Kim; Y.H. Kim; Y.S. Yang 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 666 KB

Effect of alloying time and composition

Effect of alloying time and composition on the mechanical properties of Ti alloy

✍ Margam Chandrasekaran; Zhang Su Xia 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 632 KB

Synthesis of amorphous phase in TiNiCu

Synthesis of amorphous phase in TiNiCu system by mechanical alloying

✍ Murty, B.S.; Rao, M.Mohan; Ranganathan, S. 📂 Article 📅 1990 🏛 Elsevier Science ⚖ 299 KB

Synthesis of amorphous and metastable Ti

Synthesis of amorphous and metastable Ti40Al60alloys by mechanical alloying of elemental powders

✍ W. Guo; A. Iasonna; M. Magini; S. Martelli; F. Padella 📂 Article 📅 1994 🏛 Springer 🌐 English ⚖ 847 KB

Ti4oAl~o amorphous and metastable alloys have been prepared by mechanical alloying (MA), under controlled milling conditions in a planetary mill. Three different quantities of kinetic energy at the collision instant have been achieved by using balls of different size, d~b = 5, 8 and 12 mm, keeping c