๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Combustion in fuel beds

โœ Scribed by Arthur, J. R. ;Bancham, D. H. ;Thrinc, M. W.


Publisher
Wiley (John Wiley & Sons)
Year
1949
Weight
664 KB
Volume
68
Category
Article
ISSN
0368-4075

No coin nor oath required. For personal study only.

โœฆ Synopsis


Abstract

Experiments carried out at B.C.U.R.A. in 1939โ€40 in connexion with a programme of work on producers for road transport threw doubt on the conventional โ€œtwoโ€zoneโ€ theory of producer beds taught in the textโ€books. In particular, an overwhelming proportion of the fuel was consumed within the first few particle thicknesses. Temperature measurements and gas analyses of samples taken at a series of points throughout the bed gave evidence of an apparent increase in the total energy of the gases (per unit quantity of ingoing air) on passage through the bed. The only possible explanations are: (a) systematic errors in temperature measurements, (b) systematic errors in gas analyses such as would arise if energy in some latent form were yielded up to the sampling probes. Check measurements with suction pyrometers rendered (a) highly improbable. The most probable explanation was considered to be that carbon monoxide produced as a primary combustion product of the surface reaction between carbon and oxygen bums in the voids where it reacts with the surviving oxygen. Experiments in which air was streamed through a carbon tube at 850ยฐ showed that the oxygen removal and nearly the whole of the carbon consumption took place within a pathโ€length roughly equal to a single tube diameter. This length being quite insufficient for all the oxygen to reach the carbon surface (even with a certain degree of turbulence), this experiment is taken as providing substantial evidence as to the truth of the above working hypothesis. It appears, moreover, that mere thermal quenching is insufficient to โ€œfreezeโ€ the reaction between CO and surviving oxygen. This would be at once intelligible if the reaction followed a โ€œchainโ€ mechanism as it does in vitro. Attempts were therefore made to inhibit the gas phase reaction by introducing small quantities of volatile chlorineโ€containing materials with the ingoing air, which was carefully freed from moisture. Only minimal quantities of CO~2~, now appeared in the outgoing gases, and the oxygen survival and carbon consumption were now appreciable after path lengths of about 10 tubeโ€diameters. Finally, it was found possible to muse partial inhibition of CO~2~, formation by the use of solid inhibitors (clean fused silica) remote from the carbon surface. These results were obtained at temperatures such that no appreciable reduction of CO~2~, to CO would take place.

The above findings carry important implications in regard to technical fuel beds, which begin to function 85 producers after a path length equivalent to a single particle diameter has been traversed by the ingoing air. In particular it is ordinarily necessary to run with excess air since the physical mixing of the broad stream of producer gas with secondary air is otherwise incomplete. A burner which climates this disadvantage and gives combustion gas โ€œby first intentionโ€ has been designed and is in the process of technical development.


๐Ÿ“œ SIMILAR VOLUMES


Combustion in crater beds
โœ T.I. Malik; F.J. Weinberg; J.C. Boden; J. Fuller ๐Ÿ“‚ Article ๐Ÿ“… 1987 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 890 KB

A preliminary study of a new type of heat-recirculating particulate bed combustor has been carried out with a view to overcoming some limitations arising in the scaling up of spouted bed combustors. A fountain of particles, somewhat similar to that produced in spouted beds, is raised by a jet of gas

Gas-phase combustion in fluidized beds
โœ J. F. Stubington; J. F. Davidson ๐Ÿ“‚ Article ๐Ÿ“… 1981 ๐Ÿ› American Institute of Chemical Engineers ๐ŸŒ English โš– 755 KB
Bed carbon loadings in fluid bed combust
โœ P.T. Roberts; L.C. Shirvill; L.T. Cowley ๐Ÿ“‚ Article ๐Ÿ“… 1987 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 239 KB

This note is prompted by the recent publication of Donsi et al. [1] concerning the calculation of carbon hold-up in a fluidized bed combustor. They tested the sensitivity of bed carbon content predictions to cross-flow ratio under the assumption that char particles burn to CO2 in the dense phase and