Collimation Characteristics of Planar Microlens for Parallel Optical Interconnect
β Scribed by Yasuhiko Aoki; Yuji Shimada; Kenichi Iga
- Book ID
- 106255346
- Publisher
- Optical Society of Japan
- Year
- 2000
- Tongue
- English
- Weight
- 538 KB
- Volume
- 7
- Category
- Article
- ISSN
- 1340-6000
No coin nor oath required. For personal study only.
π SIMILAR VOLUMES
## Abstract A compactβsize D lens collimator was fabricated and characterized. High circular rate 98%, small divergence angle 0.186Β°, and low return loss 59.8 dB were achieved in experiment to present the excellent performance of D lens collimator. Insertion loss sensitivity due to variation in wor
We fabricated axicon microlenses on a single-mode bare optical fiber by using selective chemical etching technique. By varying the concentration and mixture ratios of etching solutions, we could make axicon microlenses with different apex angles (118Β°, 107Β°and 90Β°). We measured the illumination and
sion line by almost 2 β and 0.5α0.75 cmrns, respectively. Because the SiO layer has a significantly lower dielectric 2 constant than that of GaAs, its inclusion will result in a smaller capacitance per unit length of the CPS slow-wave electrodes. This results in an increase in the phase velocity of