𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Coal drying improves performance and reduces emissions : Bullinger, C. et al. Proceedings of the International Technical Conference on Coal Utilization & Fuel Systems, 2002, 2, (27), 639–650

Publisher
Elsevier Science
Year
2003
Weight
277 KB
Volume
44
Category
Article
ISSN
0140-6701

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Effect of mineral matter on coal combust
Effect of mineral matter on coal combustion reactivity : Rojas, A. F. et al. Proceedings of the International Technical Conference on Coal Utilization & Fuel Systems, 2002, 1, (27), 325–331
📂 Article 📅 2003 🏛 Elsevier Science ⚖ 272 KB

A new method for estimating the average fraction of graphitic structure (the graphite-like factor) found in carbonized materials such as anthracitic coals and soots has been developed. This method employs a Q meter, a device that can be used to measure the resistance of a coil at high frequency. Th

Effect of wood fule on SO2 emissions in
Effect of wood fule on SO2 emissions in co-firing with coal in fluidized bed : Orjala, M. M. et al. Proceedings of the International Technical Conference on Coal Utilization & Fuel Systems, 2002, 1, (27), 527–538
📂 Article 📅 2003 🏛 Elsevier Science ⚖ 282 KB

15 Environment (pollution, health protection, safety) conclusion the collective dose result is shown and partly compared with that of previous ITER design stages considering the different systems and solutions and pointing out ALARA improvements. ## 03100877 Consideration and practice of science,

Experiences cofiring switchgrass at Alab
Experiences cofiring switchgrass at Alabama Power's Plant Gadsden : Zemo, B. et al. Proceedings of the International Technical Conference on Coal Utilization & Fuel Systems, 2002, 2, (27), 1109–1120
📂 Article 📅 2003 🏛 Elsevier Science ⚖ 261 KB

## Combustion (burners, combustion systems) operates at a medium pressure (4.0 MPa), two-phase flow instabilities are a difficult problem. The design must eliminate two-phase flow instabilities and the system must be tested to show that flow instability does not occur.