Characterization of a capacitive tactile shear sensor for application in robotic and upper limb prostheses

✍ Scribed by Mohsin I. Tiwana; Arridh Shashank; Stephen J. Redmond; Nigel H. Lovell

• Publisher: Elsevier Science
• Year: 2011
• Tongue: English
• Weight: 792 KB
• Volume: 165
• Category: Article
• ISSN: 0924-4247
• DOI: 10.1016/j.sna.2010.09.012

✦ Synopsis

This paper presents the characterization of a novel tactile sensor designed to measure shear forces. The sensor design is targeted for use in robotic and prosthetic hands, where haptic feedback or ability to detect shear forces associated with slip are critical. The presented sensor utilizes the principle of differential capacitance to measure the mechanical deflection of the sensor element. The dynamic range of the sensor can be varied by encapsulating the sensor terminal within silicone of varying hardness. The design features ease of mass production, low per-unit-cost, novel overload protection and low wire count, while still preserving the ability to achieve reasonable spatial resolutions and array densities. Mathematical and COMSOL multiphysics models of the sensor are presented, in addition to results from practical experiments. Sensors with a full scale displacement range of ±0.525 mm were produced and the differential capacitance was measured. Shear force transduction was characterized over the range of 0 N-4 N with the sense terminal encapsulated by silicone with a shore A hardness of 20. The effect of elastomer hardness on the sensor's dynamic range was analyzed. The differential capacitance, when measured at each fixed interval, was found experimentally to have a maximum standard deviation of 4.28e-16 F over a ±2 N range. A maximum standard deviation of 1.35e-15 F was measured across characterized full scale sensor range of ±4 N. The sensor design has a sensitivity of 1.967 fF/N of applied force and the sensor output was found to be approximately linear. The coefficient of determination, r 2 , was found to be 0.941.