𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Changes of surface morphology in UV-irradiated poly(acrylic acid)/poly(ethylene oxide) blends

✍ Scribed by Halina Kaczmarek; Aleksandra Szalla; Hanna Chaberska; Jolanta Kowalonek

Book ID
108278915
Publisher
Elsevier Science
Year
2004
Tongue
English
Weight
487 KB
Volume
566-568
Category
Article
ISSN
0039-6028

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Effect of acrylic acid content in poly(e
Effect of acrylic acid content in poly(ethylene-ran-acrylic acid) on the morphology and mechanical properties of poly(ethylene-ran-acrylic acid)/polystyrene blends compatibilized by poly(styrene-ran-glycidyl methacrylate)
✍ Sanghyo Kim; Jin Kon Kim; C.E. Park πŸ“‚ Article πŸ“… 1997 πŸ› Elsevier Science 🌐 English βš– 741 KB

Effect of acrylic acid content in poly(ethylene-ran-acrylic acid) on the morphology and mechanical properties of poly(ethylene-ran-acrylic acid)/polystyrene blends cornpatibilized by poly(styrene-ranglycidyl methacrylate)

Spin label study of phase morphology and
Spin label study of phase morphology and polymer segmental motion in poly(acrylic acid)–poly(ethylene oxide) complex
✍ Li Tan; Guangqiang Lu; Shiming Chen; Zhenghua Ping; Yimin Shen πŸ“‚ Article πŸ“… 2003 πŸ› John Wiley and Sons 🌐 English βš– 119 KB πŸ‘ 1 views

## Abstract The ESR lineshapes of nitroxide radical end‐labeled on poly(ethylene oxide) (SLPEO) for the pure polymer and for different weight ratio complexes with poly(acrylic acid) (PAA) were studied as a function of temperature. For SLPEO one spectral component was detected in the entire temperat

Poly(ethylene-graft-ethylene oxide) (PE-
Poly(ethylene-graft-ethylene oxide) (PE-PEO) and poly(ethylene-co-acrylic acid) (PEAA) as compatibilizers in blends of LDPE and polyamide-6
✍ Γ…sa HalldΓ©n; Bertil Ohlsson; Bengt WesslΓ©n πŸ“‚ Article πŸ“… 2000 πŸ› John Wiley and Sons 🌐 English βš– 366 KB πŸ‘ 2 views

In a blend of two immiscible polymers a controlled morphology can be obtained by adding a block or graft copolymer as compatibilizer. In the present work blends of low-density polyethylene (PE) and polyamide-6 (PA-6) were prepared by melt mixing the polymers in a co-rotating, intermeshing twin-screw