✦ LIBER ✦

Capillary rheometry of polymer melts — Simulation and experiment

✍ Scribed by Seppo Syrjälä, Johanna Aho

Book ID: 118303598
Publisher: Korean Society of Rheology, Australian Society of Rheology
Year: 2012
Tongue: English
Weight: 261 KB
Volume: 24
Category: Article
ISSN: 1226-119X
DOI: 10.1007/s13367-012-0029-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Capillary rheometry for polymer melts

✍ Jean-Michel Piau 📂 Article 📅 2005 🏛 Springer-Verlag 🌐 English ⚖ 120 KB

Capillary rheometry for polymer melts re

Capillary rheometry for polymer melts revisited

✍ Hans Martin Laun 📂 Article 📅 2004 🏛 Springer-Verlag 🌐 English ⚖ 949 KB

Rheometry of Polymer Melts

✍ Meissner, Joachim 📂 Article 📅 1985 🏛 Annual Reviews 🌐 English ⚖ 781 KB

Pressure dependent viscosity and dissipa

Pressure dependent viscosity and dissipative heating in capillary rheometry of polymer melts

✍ HansMartin Laun 📂 Article 📅 2003 🏛 Springer-Verlag 🌐 English ⚖ 405 KB

A calorimetric measurement of frictional

A calorimetric measurement of frictional heat in capillary rheometry of polymer melts

✍ R. Daryanani; H. Janeschitz-Kriegl; R. van Donselaar; J. van Dam 📂 Article 📅 1973 🏛 Springer-Verlag 🌐 English ⚖ 602 KB

A comparison of torsional and capillary

A comparison of torsional and capillary rheometry for polymer melts: The Cox-Merz rule revisited

✍ S. Venkatraman; M. Okano 📂 Article 📅 1990 🏛 Society for Plastic Engineers 🌐 English ⚖ 557 KB

## Abstract Rheological properties of high and low density polyethylene melts (HOPE and LDPE) were measured under two different deformation modes: sinusoidal strain (“dynamic”) and constant rate‐of‐strain (“steady‐state”). For the sinusoidal measurements, a torsional geometry was used, whereas the