Calculation of distribution system voltage and power flow state using measured values

✍ Scribed by Kenichi Tanomura; Yoshihiro Ogita; Yumiko Kaneshige; Junji Ishii; Junichi Arai

• Publisher: John Wiley and Sons
• Year: 2008
• Tongue: English
• Weight: 904 KB
• Volume: 164
• Category: Article
• ISSN: 0424-7760
• DOI: 10.1002/eej.20416

✦ Synopsis

Abstract

This paper describes a techique of calculating voltage and power flow state of a distribution system using the information measured with two or more switches with sensors installed in a distribution system. In the proposed technique, a set of the power distribution section where two or more switches with a sensor are connected is defined as the large section, and the active power and reactive power consumption in the large section are calculated based on measurement information, voltage (RMS), current (RMS), and power factor. Using the simple distribution system model consisting of the large sections, the power consumption of the large section is calculated by the power flow calculation to separate power consumption and power distribution loss. It is distributed to the small sections that constitute the large section, and detailed power flow calculation is performed. Verification of the proposed technique and basic estimation of the calculation error were performed using the simple power distribution system model. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(4): 33–42, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/eej.20416