✦ LIBER ✦

Blended elemental powder densification of Ti-6Al-4V by hot pressing

✍ Scribed by Ye, Bing; Matsen, Marc R.; Dunand, David C.

Book ID: 118250327
Publisher: Cambridge University Press
Year: 2011
Tongue: English
Weight: 513 KB
Volume: 26
Category: Article
ISSN: 0884-2914
DOI: 10.1557/jmr.2011.26

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Modeling of hot isostatic pressing and h

Modeling of hot isostatic pressing and hot triaxial compaction of Ti–6Al–4V powder

✍ D.P. DeLo; R.E. Dutton; S.L. Semiatin; H.R. Piehler 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 241 KB

AbstractÐThe accuracy of a hybrid continuum±micromechanical model for predicting the rate-dependent consolidation of metal powder was established using measurements from hot isostatic pressing (HIP) and hot triaxial compaction (HTC) experiments. The experiments were performed with PREP 1 Ti±6Al±4V p

Influence of cold and hot pressing on de

Influence of cold and hot pressing on densification behaviour of titanium alloy powder Ti6Al4V

✍ Z. GRONOSTAJSKI; P. BANDOŁA; T. SKUBISZEWSKI 📂 Article 📅 2009 🏛 Elsevier 🌐 English ⚖ 960 KB

Early stage consolidation mechanisms dur

Early stage consolidation mechanisms during hot isostatic pressing of Ti–6Al–4V powder compacts

✍ D.P. DeLo; H.R. Piehler 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 308 KB

Microstructure and Mechanical Properties

Microstructure and Mechanical Properties of Laser Solid Formed Ti-6Al-4V from Blended Elemental Powders

✍ Tan Hua; Chen Jing; Zhang Fengying; Lin Xin; Huang Weidong 📂 Article 📅 2009 🏛 Elsevier ⚖ 616 KB

In situ TiBw/Ti–6Al–4V composites with n

In situ TiBw/Ti–6Al–4V composites with novel reinforcement architecture fabricated by reaction hot pressing

✍ L.J. Huang; L. Geng; A.B. Li; F.Y. Yang; H.X. Peng 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 287 KB

Process optimization of Ti–Nb alloy coat

Process optimization of Ti–Nb alloy coatings on a Ti–6Al–4V plate using a fiber laser and blended elemental powders

✍ Vahid Fallah; Stephen F. Corbin; Amir Khajepour 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 762 KB

A fiber laser was used to modify the surface composition of a Ti-6Al-4V plate through deposition of the blown powder mixture of Ti-45 wt.%Nb. Scanning electron microscopy and energy dispersive spectroscopy (EDS) were employed to examine the clad sections microstructure and chemical composition. The