✦ LIBER ✦

Behavioral model for reducing the complexity of mixer analysis and design

✍ Scribed by A. Cidronali; G. Loglio; J. Jargon; G. Manes

Publisher: John Wiley and Sons
Year: 2005
Tongue: English
Weight: 301 KB
Volume: 15
Category: Article
ISSN: 1096-4290
DOI: 10.1002/mmce.20092

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Characterization and modeling of nonline

Characterization and modeling of nonlinear mixer behavior for 77-GHz radar systems

✍ Markus Treml; Christoph Wagner; Andreas Stelzer; Herbert Jäger 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 116 KB

## Abstract A behavioral model describing the behavior of active mixers in the linear and the saturation mode of operation is presented. The model allows the simulation of effects caused by high‐level blocking signals. A 77‐GHz multi‐tone signal is used for characterizing the nonlinear behavior of

Interpolation among reduced-order matric

Interpolation among reduced-order matrices to obtain parameterized models for design, optimization and probabilistic analysis

✍ Joris Degroote; Jan Vierendeels; Karen Willcox 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 266 KB

Models for the design and analysis of a

Models for the design and analysis of a large package sort facility

✍ Paul McAree; Lawrence Bodin; Michael Ball 📂 Article 📅 2002 🏛 John Wiley and Sons 🌐 English ⚖ 359 KB

CONVEX MODEL FOR SEISMIC DESIGN OF STRUC

CONVEX MODEL FOR SEISMIC DESIGN OF STRUCTURES—I: ANALYSIS

✍ PANTELIDES, C. P.; TZAN, S.-R. 📂 Article 📅 1996 🏛 John Wiley and Sons 🌐 English ⚖ 972 KB

A convex model is used to estimate the maximum response of structural systems subjected to uncertain seismic excitations. The convex modal is based on the assumption that the energy of the excitation is bounded . A reduction factor, defined in the modal domain by dividing the results obtained from t

Experimental designs and response surfac

Experimental designs and response surface modeling applied for the optimization of metal-cyanide complexes analysis by capillary electrophoresis

✍ Vicens Martí; Manuel Aguilar; Adriana Farran 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 English ⚖ 202 KB 👁 2 views

Design and modeling of RF MEMS switch by

Design and modeling of RF MEMS switch by reducing the number of interfaces

✍ N. Sboui; A. Gharsallah; H. Baudrand; A. Gharbi 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 English ⚖ 215 KB

## Abstract The transverse wave concept iterative procedure is presented for full wave investigation of MEMS capacitive switch. Using the transverse wave approach we can reduce the number of interfaces in planar circuit by the introduction of adequate boundary conditions. The circuit plane includes