𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Application of Taguchi techniques to study dry sliding wear behaviour of metal matrix composites

✍ Scribed by S. Basavarajappa; G. Chandramohan; J. Paulo Davim

Book ID
108200694
Publisher
Elsevier Science
Year
2007
Weight
179 KB
Volume
28
Category
Article
ISSN
0261-3069

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Optimization of testing parameters on th
Optimization of testing parameters on the wear behaviour of metal matrix composites based on the Taguchi method
✍ Y. Sahin πŸ“‚ Article πŸ“… 2005 πŸ› Elsevier Science 🌐 English βš– 303 KB

The weight loss model of aluminium alloy composites with 10 wt.% SiC particles by molten metal mixing method was developed in terms of abrasive grain size, reinforcement size used in the composite, applied load and sliding distance using the Taguchi method. The two-body abrasive wear behaviour of th

Some studies on drilling of hybrid metal
Some studies on drilling of hybrid metal matrix composites based on Taguchi techniques
✍ S. Basavarajappa; G. Chandramohan; J. Paulo Davim πŸ“‚ Article πŸ“… 2008 πŸ› Elsevier Science 🌐 English βš– 372 KB

Drilling is a metal removal process and is important for the final fabrication stage prior to application. This paper discusses the influence of cutting parameters on drilling characteristics of hybrid metal matrix composites (MMCs)-Al2219/15SiCp and Al2219/15SiCp-3Gr. The composites are fabricated

Dry sliding wear behavior of in situ Al–
Dry sliding wear behavior of in situ Al–Al4C3 metal matrix composite produced by mechanical alloying technique
✍ Halil Arik; Yusuf Ozcatalbas; Mehmet Turker πŸ“‚ Article πŸ“… 2006 πŸ› Elsevier Science βš– 570 KB

Dry sliding wear behavior of in situ Al-Al 4 C 3 composite produced by mechanical alloying technique was examined. Mechanically alloyed Al-C powders were compacted at 650 MPa to produce the blanks with the size of ΓΈ10 β€’ 25 mm. These blanks were then sintered at 650 Β°C for 20 h and MMC samples with t