𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Application of 2D FEM to chip formation in orthogonal cutting

✍ Scribed by E. Ceretti; P. Fallböhmer; W.T. Wu; T. Altan

Book ID
108027689
Publisher
Elsevier Science
Year
1996
Tongue
English
Weight
922 KB
Volume
59
Category
Article
ISSN
0924-0136

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Extension of basic geometric analysis of
Extension of basic geometric analysis of 3-D chip forms in metal cutting to chips with obstacle-induced deformation
✍ A.G. Kharkevich; Patri K. Venuvinod 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 377 KB

In machining, chips are known to break mainly because of obstacle-induced deformation. Recently, the present authors had reported on a new and basic geometric analysis of 3-D chips in the absence of deformation after separation from the tool rake face. This paper continues the analysis to cover the

A Distributed Formation of Smallest Faul
A Distributed Formation of Smallest Faulty Orthogonal Convex Polygons in 2-D Meshes
✍ Jie Wu 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 229 KB

The rectangular faulty block model is the most commonly used fault model for designing fault-tolerant and deadlock-free routing algorithms in meshconnected multicomputers. The convexity of a rectangle facilitates simple and efficient ways to route messages around fault regions using relatively few v