✦ LIBER ✦

Anodic sampling of different alloys

✍ Scribed by Dr.-Ing. Z. Medanić; Dipl.-Ing. V. Ivanković; Dr.-Ing. S. Turina

Publisher: John Wiley and Sons
Year: 1993
Tongue: English
Weight: 314 KB
Volume: 24
Category: Article
ISSN: 0933-5137
DOI: 10.1002/mawe.19930240514

No coin nor oath required. For personal study only.

✦ Synopsis

Abstract

This research work was carried out to find the optimum conditions for anodic sampling of steels, aluminium alloys, brass etc. It was found using electrolyte: the water solution of ammon‐nitrat (1 g/l) and hydrochloric acid (conc.) in volume ratio 1:1, give the best results if the duration of electrochemical process was 45 s and D.C. current was 4.5 V.

The elements which are sampled were datected by thin layer chromatography and optical emission spectrometry.

📜 SIMILAR VOLUMES

Anodic behavior of Fe40Ni40B20 and Fe39N

Anodic behavior of Fe40Ni40B20 and Fe39Ni39B10Si12 amorphous alloys

✍ M. Janik-Czachor 📂 Article 📅 1983 🏛 John Wiley and Sons 🌐 German ⚖ 409 KB

Amorphous alloys Fe40Ni40B2,, and Fe3yNi3yB,0Si12 exhibit a typical active/passive transition when anodically polarized in borate and/or phthalate buffer solutions, at pH = 4.0; 5.3; 6.3 and 8.4. There is no large effect of Si on the anodic behaviour of the alloys in these media. Both alloys underg

Anodic passivity of some titanium base a

Anodic passivity of some titanium base alloys in aggressive environments

✍ M. V. Popa; E. Vasilescu; P. Drob; M. Anghel; C. Vasilescu; I. Mirza-Rosca; A. S 📂 Article 📅 2002 🏛 John Wiley and Sons 🌐 German ⚖ 118 KB

Characterisation of anodic films formed

Characterisation of anodic films formed on titanium and its alloys

✍ J.C. Mirza Rosca; E.D. Herrera Santana; J. Rodriguez Castro; A. Santana Lopez; E 📂 Article 📅 2005 🏛 John Wiley and Sons 🌐 German ⚖ 205 KB

The properties of the anodic oxide films formed on titanium and its implant alloys Ti-5Al-4V and Ti-6Al-4Fe are investigated in this paper. Anodic oxide films were prepared by electrochemical treatment in 3M sulphuric acid solution at 60 V for 1 min, followed by a thermal treatment consisting of hea

The anodic properties of FeCr alloys in

The anodic properties of FeCr alloys in organic solvents

✍ Jacek Banaś 📂 Article 📅 1982 🏛 Elsevier Science 🌐 English ⚖ 748 KB

Anodic dissolution of binary single phas

Anodic dissolution of binary single phase alloys at subscritical potential

✍ J. Laurent; D. Landolt 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 770 KB

Anodic behavior of NiP alloys studied b

Anodic behavior of NiP alloys studied by impedance spectroscopy

✍ A. Królikowski; P. Butkiewicz 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 428 KB

## A&met -Anodic behavior of electrodeposited Ni-P alloys with P content ranging from 6 to 28 at% was investigated in chloride and sulphate neutral solutions. Measurements were performed by potentiodynamic polarization and impedance spectroscopy methods. It was found that the tested alloys exhibit