✦ LIBER ✦

Anisotropic shrinkage during sintering of injection moulded parts

Book ID: 117182143
Publisher: Elsevier Science
Year: 2001
Tongue: English
Weight: 124 KB
Volume: 56
Category: Article
ISSN: 0026-0657
DOI: 10.1016/s0026-0657(01)80548-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A furnace for debinding and sintering of

A furnace for debinding and sintering of injection moulded parts

📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 161 KB

Part shrinkage anomilies from stereolith

Part shrinkage anomilies from stereolithography injection mould tooling

✍ R.A Harris; H.A Newlyn; R.J.M Hague; P.M Dickens 📂 Article 📅 2003 🏛 Elsevier Science 🌐 English ⚖ 235 KB

Better simulation of injection moulded p

Better simulation of injection moulded parts

📂 Article 📅 1997 🏛 Elsevier Science 🌐 English ⚖ 311 KB

Anisotropic shrinkage of barium-magnesiu

Anisotropic shrinkage of barium-magnesium aluminosilicate glass powder compacts during sintering

✍ A.R. Boccaccini; P.A. Trusty; D.M.R. Taplin 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 623 KB

Anisotropic shrinkage of injection-molde

Anisotropic shrinkage of injection-molded rubber

✍ Kunihiko Nakashima; Hiroshi Fukuta; Minoru Mineki 📂 Article 📅 1973 🏛 John Wiley and Sons 🌐 English ⚖ 796 KB

## Abstract The anisotropic characteristics of injection‐molded flat rubber sheets were investigated. The shrinkage and mechanical properties were measured in two directions: parallel and perpendicular to the flow direction. The results showed that (1) the shrinkage in the parallel direction is lar

Continuous catalytic debinding and sinte

Continuous catalytic debinding and sintering of metal injection moulded parts : I. Cremer (Cremer GmbH, Düren, Germany)

📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 157 KB