✦ LIBER ✦

Analysis of tool wear and surface finish in hard turning

✍ Scribed by T. Tamizharasan; T. Selvaraj; A. Noorul Haq

Publisher: Springer
Year: 2005
Tongue: English
Weight: 669 KB
Volume: 28
Category: Article
ISSN: 0268-3768
DOI: 10.1007/s00170-004-2411-1

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Modelling of CBN tool crater wear in fin

Modelling of CBN tool crater wear in finish hard turning

✍ Yong Huang; Steven Y. Liang 📂 Article 📅 2004 🏛 Springer 🌐 English ⚖ 977 KB

Correlating tool life, tool wear and sur

Correlating tool life, tool wear and surface roughness by monitoring acoustic emission in finish turning

✍ A.E. Diniz; J.J. Liu; D.A. Dornfeld 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 962 KB

Correlating tool wear, tool life, surfac

Correlating tool wear, tool life, surface roughness and tool vibration in finish turning with coated carbide tools

✍ M.E.R. Bonifacio; A.E. Diniz 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 947 KB

Modelling of multivariate time series fo

Modelling of multivariate time series for tool wear estimation in finish-turning

✍ Y. Yao; X.D. Fang 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 967 KB

Flank wear prediction of ceramic tools i

Flank wear prediction of ceramic tools in hard turning

✍ Dilbag Singh; P. Venkateswara Rao 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 381 KB

Influence of tool flank wear on performa

Influence of tool flank wear on performance of finish hard machined surfaces in rolling contact

✍ Youngsik Choi 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 561 KB

This study investigates the influence of tool flank wear on the performance of finish hard machined surfaces in rolling contact. The residual stress and micro-hardness distribution below the machined surface and the surface roughness of the machined surface were measured to investigate the rolling c