๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Analysis of particle motion and heat transfer in circulating fluidized beds

โœ Scribed by Y. Tian; X.F. Peng


Publisher
John Wiley and Sons
Year
2004
Tongue
English
Weight
158 KB
Volume
28
Category
Article
ISSN
0363-907X

No coin nor oath required. For personal study only.


๐Ÿ“œ SIMILAR VOLUMES


Single-particle motion and heat transfer
โœ Yee Sun Wong; Jonathan P. K. Seville ๐Ÿ“‚ Article ๐Ÿ“… 2006 ๐Ÿ› American Institute of Chemical Engineers ๐ŸŒ English โš– 288 KB ๐Ÿ‘ 3 views

## Abstract Fluidized beds are particularly favored as chemical reactors because of their ability to exchange heat through immersed heatโ€exchange surfaces. However, little is known about how the heatโ€exchange process works on a singleโ€particle level. The most commonly applied theory of fluidized be

Heat transfer mechanisms in gas fluidize
โœ Prof. Dr.-Ing. Otto Molerus; Dr.-Ing. Wolfgang Mattmann ๐Ÿ“‚ Article ๐Ÿ“… 1992 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 340 KB ๐Ÿ‘ 2 views

Part 1 of this contribution reported on the effects of system properties on heat transfer between heating or cooling surfaces and bubbling fluidized beds. This investigation produced four correlations which define the respective maximum heat transfer. Part 2 of this study suggests that the heat tran

Heat transfer characteristics of liquidโ€“
โœ Kenichi Hashizume; Yoichi Kimura ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 401 KB ๐Ÿ‘ 1 views

## Abstract An experiment was conducted to obtain heat transfer data in liquidโ€“solid circulating fluidized beds. In the experiment, two kinds of risers were provided, their inner diameter being 24 mm and 12 mm, respectively. Tested particles were of glass and ceramics, having a diameter range from

Axial and radial heat transfer studies i
โœ B. V. Reddy; P. K. Nag ๐Ÿ“‚ Article ๐Ÿ“… 1997 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 466 KB ๐Ÿ‘ 2 views

The axial and radial variation of the heat transfer coefficient in a circulating fluidized bed riser column, and the effect of operating parameters thereon, are investigated. The experimental set-up consists of a riser column of 102 mm;102 mm in bed cross-section, 5โ€ข25 m in height with a return leg