✦ LIBER ✦

Analysis of elliptical cup drawing process of stainless sheet metal

✍ Scribed by Yuung-ming HUANG; Shiao-cheng LU

Book ID: 117694480
Publisher: Elsevier Science
Year: 2011
Tongue: English
Weight: 819 KB
Volume: 21
Category: Article
ISSN: 1003-6326
DOI: 10.1016/s1003-6326(11)60724-3

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Analysis of deep drawing of sheet metal

Analysis of deep drawing of sheet metal using the Marform process

✍ Maziar Ramezani; Zaidi Mohd Ripin 📂 Article 📅 2011 🏛 Springer 🌐 English ⚖ 809 KB

Experimental and numerical analysis of t

Experimental and numerical analysis of the cup drawing test for orthotropic metal sheets

✍ L.P Moreira; G Ferron; G Ferran 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 374 KB

The numerical analysis of anisotropic sh

The numerical analysis of anisotropic sheet metals in deep-drawing processes

✍ Y.Q. Liu; J.C. Wang; P. Hu 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 500 KB

CAE-Based six sigma robust optimization

CAE-Based six sigma robust optimization for deep- drawing process of sheet metal

✍ Y. Q. Li; Z. S. Cui; X. Y. Ruan; D. J. Zhang 📂 Article 📅 2006 🏛 Springer 🌐 English ⚖ 287 KB

Experimental and numerical (FEM) analysi

Experimental and numerical (FEM) analysis of deep drawing of relatively thick sheet metal

✍ Z. Kampuš; K. Kuzman 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 432 KB

The paper deals with an analysis of deep drawing without blankholder with special emphasis on workpiece geometry. The process was simulated by the FEM using a rigid--plastic model. Because of a relatively small forming speed (a hydraulic press is normally used) and small deformations, temperature wa

A finite element analysis of the flange

A finite element analysis of the flange earrings of strong anisotropic sheet metals in deep-drawing processes

✍ Liu Yuqi; Wang Jincheng; Hu Ping 📂 Article 📅 2002 🏛 The Chinese Society of Theoretical and Applied Mec 🌐 English ⚖ 887 KB