✦ LIBER ✦

Analysis of carbides in AISI type 304 and 304L stainless steel after different thermal treatments

✍ Scribed by A. Benvenuti; G. Chevallard

Publisher: Elsevier Science
Year: 1983
Tongue: English
Weight: 87 KB
Volume: 12
Category: Article
ISSN: 0304-3991
DOI: 10.1016/0304-3991(83)90350-9

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Artificial neural network modeling to ev

Artificial neural network modeling to evaluate and predict the deformation behavior of stainless steel type AISI 304L during hot torsion

✍ Sumantra Mandal; P.V. Sivaprasad; S. Venugopal; K.P.N. Murthy 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 883 KB

Scanning AES and chemical investigation

Scanning AES and chemical investigation of materials failure due to phosphorus and sulphur grain boundary segregation in type AISI 304L stainless steel

✍ G. Barkleit; A. John; F. Schneider 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 German ⚖ 221 KB 👁 1 views

Improvement of pitting corrosion resista

Improvement of pitting corrosion resistance of AISI 444 stainless steel to make it a possible substitute for AISI 304L and 316L in hot natural waters

✍ T. Bellezze; G. Roventi; A. Quaranta; R. Fratesi 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 German ⚖ 451 KB 👁 1 views

## Abstract The pitting corrosion resistance of AISI 444, 304L and 316L stainless steels in two tap waters with different chloride concentrations at 80 °C was studied. Cyclic potentiodynamic polarization (CPP) tests were carried out starting from __E__~corr~ − 30 mV until the current density reache

Microstructure and microhardness analysi

Microstructure and microhardness analysis of the hexagonal oxides formed on the surface of the AISI 304 stainless steel after Nd:YAG pulsed laser surface melting

✍ C.Y. Cui; X.G. Cui; Y.K. Zhang; K.Y. Luo; Q. Zhao; J.D. Hu; Z. Liu; Y.M. Wang 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 811 KB

The laser surface melting (LSM) technique was adopted to modify the surface layer microstructure of the AISI 304 stainless steel in this paper. The results showed that the hexagonal morphologies have been successfully fabricated on the surface after LSM. These hexagons had side lengths of about 0.5-

Dependence of outgassing rate on surface

Dependence of outgassing rate on surface oxide layer thickness in type 304 stainless steel before and after surface oxidation in air

✍ K Odaka; S Ueda 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 411 KB

High temperature low cycle fatigue behav

High temperature low cycle fatigue behaviour of AISI 304L stainless steel base metal and weldment: Lee, S.C. and Nam, S.W. J. Korean Inst. Met. Jan. 1989 27, (1), 32–39 (in Korean)

📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 172 KB