𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Analysis and measurement of neck loads

✍ Scribed by Sean P. Moroney; Albert B. Schultz; James A. A. Miller


Publisher
Elsevier Science
Year
1988
Tongue
English
Weight
716 KB
Volume
6
Category
Article
ISSN
0736-0266

No coin nor oath required. For personal study only.

✦ Synopsis


To examine the loads imposed on the structures of the neck by the performance of physical tasks, a biomechanical model of the neck was constructed. The model incorporated 14 bilateral pairs of muscle equivalents crossing the C4 level. A double linear programming optimization scheme that minimized maximum muscle contraction intensity and then vertebral compression force while equilibrating external loads was used to calculate the muscle contraction forces required and the motion segment reactions produced by task performance. To test model validity, 14 healthy adult subjects performed a series of isometric tasks requiring use of their neck muscles. These tasks included exertions in attempted flexion, extension, and left and right lateral bending and twisting. Subjects exerted maximum and submaximum voluntary efforts. During the performance, surface myoelectric activities were recorded at eight locations around the periphery of the neck at the C4 level. Calculated forces and measured myoelectric activities were then linearly correlated. Mean measured voluntary neck strengths in 10 male subjects were as large as 29.7 Nm. Four female subjects developed mean strengths that were approximately 60%-90% of those of the males. In both sexes, neck muscle strengths were approximately one order of magnitude lower than previously measured lumbar trunk strengths. Mean calculated neck muscle contraction forces ranged to 180 N. Mean calculated compression forces on the C4-5 motion segment ranged to 1164 N, lateral shear forces ranged to 125 N, and anteroposterior shear forces ranged to 135 N. Correlation coefficients between the calculated muscle forces and the measured myoelectric activities were as large as 0.85 in some muscles, but generally were smaller than this.


πŸ“œ SIMILAR VOLUMES


Transformation of dynamic loads into equ
✍ W. S. Choi; G. J. Park πŸ“‚ Article πŸ“… 1999 πŸ› John Wiley and Sons 🌐 English βš– 163 KB πŸ‘ 1 views

All the forces in the real-world act dynamically on structures. Since dynamic loads are extremely di$cult to handle in analysis and design, static loads are usually utilized with dynamic factors. Static loads are especially exploited well in structural optimization where many analyses are carried ou

MEASUREMENT OF STEADY AND UNSTEADY HYDRO
✍ B.A.W. SMITH; D.D. DERKSEN πŸ“‚ Article πŸ“… 1998 πŸ› Elsevier Science 🌐 English βš– 622 KB

A test rig was developed to measure the steady and unsteady hydrodynamic loads on a nuclear fuel bundle, as part of an investigation of wear in the fuel channels of pressurized heavy-water nuclear reactors. This paper describes the design, calibration, and operation of the test rig. Steady and unste

Neck electrical impedance for measuremen
✍ Yoshitake Yamamoto; Takao Nakamura; Yasuhiko Seki; Kinya Utsuyama; Ken Akashi; K πŸ“‚ Article πŸ“… 2000 πŸ› John Wiley and Sons 🌐 English βš– 177 KB

Recently, videofluorography has been used for evaluation of swallowing function in the rehabilitation field. But it is not easy to evaluate swallowing disorders simply. In addition, there are problems of exposure for daily use. We have proposed a measurement method of swallowing using bioelectrical

MRI texture analysis of femoral neck: De
✍ Lara C.V. Harrison; Riku Nikander; Minna SikiΓΆ; Tiina Luukkaala; Mika T. Helmine πŸ“‚ Article πŸ“… 2011 πŸ› John Wiley and Sons 🌐 English βš– 414 KB

## Abstract ## Purpose: To assess the ability of co‐occurrence matrix‐based texture parameters to detect exercise load‐associated differences in MRI texture at the femoral neck cross‐section. ## Materials and Methods: A total of 91 top‐level female athletes representing five differently loading