𝔖 Bobbio Scriptorium
✦   LIBER   ✦

An interconnect configuration between a microstrip line and a rectangular waveguide

✍ Scribed by L. T. Hildebrand; J. Joubert

Book ID
101269869
Publisher
John Wiley and Sons
Year
1997
Tongue
English
Weight
137 KB
Volume
14
Category
Article
ISSN
0895-2477

No coin nor oath required. For personal study only.

✦ Synopsis

This article presents results of an interconnect configuration between a microstripline and a rectangular wa¨eguide. Electromagnetic coupling takes place through a slot in the narrow wall of the rectangular wa¨eguide, which coincides with a slot in the ground plane of the dielectric slab. Introduction of an E-plane wa¨eguide fin yields additional control o¨er the insertion loss le¨el.

📜 SIMILAR VOLUMES

Electromagnetic interconnection between
Electromagnetic interconnection between microstrip lines through a thick ground plate
✍ Byungje Lee; Myun-Joo Park 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 347 KB

## Abstract Understanding of electromagnetic coupling is an important area of research in the design and development of multi‐layered antenna arrays. In this paper, the spectral domain moment method (SDMM) is developed to investigate the coupling between two microstrip lines through a circular wave

Broadband transition between microstrip
Broadband transition between microstrip line and WR15 rectangular waveguide using low-temperature cofired ceramic process
✍ Hong-Yeol Lee; Young-Goo Kim; Dong-Suk Jun; Ik-Guen Choi; Kang-Ho Park; Jongdae 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 389 KB

## Abstract A compact aperture coupled patch type microstrip‐to‐waveguide transition at V‐band is proposed and fabricated using low‐temperature cofired ceramic process. It uses the aperture coupled microstrip feed and the parasitic patch antenna radiating into the waveguide to improve the insertion

An approximate parallel-plate waveguide
An approximate parallel-plate waveguide model of a lossy multilayered microstrip line
✍ G. A. Kouzaev; M. J. Deen; N. K. Nikolova; A. Rahal 📂 Article 📅 2005 🏛 John Wiley and Sons 🌐 English ⚖ 128 KB

has been achieved. Slight discrepancies are due to mechanical tolerances of the fabricate prototype, which was built using mechanical etching [6]. The total dimension of the filter is 35.0 mm, corresponding to 50% of the size of a conventional E-plane filter with same specifications. The upper 3-dB