An experimental study of droplet ignition characteristics near the ignitable limit
โ Scribed by T. Saitoh; S. Ishiguro; T. Niioka
- Publisher
- Elsevier Science
- Year
- 1982
- Tongue
- English
- Weight
- 291 KB
- Volume
- 48
- Category
- Article
- ISSN
- 0010-2180
No coin nor oath required. For personal study only.
โฆ Synopsis
The present paper reports the experimental results for ignition characterisitcs of a fuel droplet near the ignitable limit. It is found experimentally that the ignition time increases as the droplet diameter decreases at the region near the ignition limits, and that, over the broad range, ignition occurs more rapidly as the diameter increases if the initial droplet temperature is high. The reason why such pehnomena occur is examined.
A comparison between the results of Faeth and Olson and the present ones is made and the discrepancies discussed. The effect of initial droplet temperature on ignition is examined. The general trends agree with the results of computation obtained previously.
๐ SIMILAR VOLUMES
The spontaneous ignition of a premixed silane-oxygen-nitrogen system has been investigated under a variety of conditions. It has been found that the autoignition temperatures are lower than room temperature if the oxygen concentration is extremely low. The spontaneous ignition of silane results from
Silicones comprise a wide variety of materials such as fluids, elastomers, resins, and foams. This paper reports the ignitability of some typical silicones under various external radiant heat fluxes. The ignitability of silicones was studied using a cone calorimeter under radiant heat flux levels of
A laboratory study of the ignition of building details incorporating timber, under bushfire conditions, using 'mock-ups' of these details and both realistic (leaves and twigs) and, mainly, artificial (cribs) ignition sources has been carried out. Parameters such as mock-up type, moisture content of
There are a number of different designs for high-energy spark igniters of the sort where sufficient energy is dissipated in the discharge so that the plasma is injected into the gas mixture that is to be ignited. The efficiency of such igniters can be expected to be a function of the injection mecha