✦ LIBER ✦

An analysis of the debris in ultrasonic-assisted electrical discharge machining

✍ Scribed by V.S.R. Murti; P.K. Philip

Book ID: 107872133
Publisher: Elsevier Science
Year: 1987
Tongue: English
Weight: 834 KB
Volume: 117
Category: Article
ISSN: 0043-1648
DOI: 10.1016/0043-1648(87)90258-4

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

An analysis of surface erosion in electr

An analysis of surface erosion in electrical discharge machining

✍ S. Tariq Jilani; P.C. Pandey 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 636 KB

Dimensional analysis of tool wear in ele

Dimensional analysis of tool wear in electrical discharge machining

✍ M.L. Jeswani 📂 Article 📅 1979 🏛 Elsevier Science 🌐 English ⚖ 542 KB

An experimental investigation of tool we

An experimental investigation of tool wear in electric discharge machining

✍ Ali Ozgedik; Can Cogun 📂 Article 📅 2005 🏛 Springer 🌐 English ⚖ 783 KB

An Investigation into Improving Worn Ele

An Investigation into Improving Worn Electrode Reliability in the Electrical Discharge Machining Process

✍ J. L. Lin; K. S. Wang; B. H. Yan; Y. S. Tarng 📂 Article 📅 2000 🏛 Springer 🌐 English ⚖ 128 KB

An experimental study for determination

An experimental study for determination of the effects of machining parameters on surface roughness in electrical discharge machining (EDM)

✍ Yusuf Keskin; H. Selçuk Halkacı; Mevlüt Kizil 📂 Article 📅 2005 🏛 Springer 🌐 English ⚖ 237 KB

Formation of a crater in the workpiece o

Formation of a crater in the workpiece on an electrical discharge machine

✍ B. Bojorquez; R.T. Marloth; O.S. Es-Said 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 258 KB

A steel molding of ASTM A681 developed a large crater while being fabricated on an electrical discharge machine. Most probably, the fault was caused by inadequate ¯ushing of the dielectric/coolant.