✦ LIBER ✦

An Analysis of Latch Comparator Offset Due to Load Capacitor Mismatch

✍ Scribed by Nikoozadeh, Amin ;Murmann, Boris

Book ID: 118167885
Publisher: IEEE
Year: 2006
Tongue: English
Weight: 171 KB
Volume: 53
Category: Article
ISSN: 1057-7130
DOI: 10.1109/tcsii.2006.883204

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Dynamic analysis of an inclined beam due

Dynamic analysis of an inclined beam due to moving loads

✍ Jia-Jang Wu 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 635 KB

It has been found that if each of the moving loads on the beam is considered as a moving mass element, then one can easily formulate the problem with all the pertinent factors relating to the multiple moving loads considered. To this end, the property matrices of the moving mass element are derived

AEPs at the onset and offset of repetiti

AEPs at the onset and offset of repetitive sound modulation, due to mismatch with the contents of an auditory sensory store

✍ S.J. Jones 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 612 KB

Analysis of thermal stresses due to movi

Analysis of thermal stresses due to moving frictional load in an infinite elastic layered medium

✍ L.S. Chen; H.S. Chu; J.H. Wu 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 710 KB

Elastodynamic analysis at an interface o

Elastodynamic analysis at an interface of viscous fluid/thermoelastic micropolar honeycomb medium due to inclined load

✍ Rajneesh Kumar; Rajani Rani Gupta 📂 Article 📅 2009 🏛 Springer 🌐 English ⚖ 599 KB

Approximate method for analysis of the c

Approximate method for analysis of the contact temperature and pressure due to frictional load in an elastic layered medium

✍ R.D. Kulchytsky-Zhyhailo; A.A. Yevtushenko 📂 Article 📅 1998 🏛 Elsevier Science 🌐 English ⚖ 731 KB

The present paper consists of two parts. The first part deals with the analysis of a temperature and the stress-strain state of the layered half-space by normal traction and is heated by heat flux distributed over the circle region of the top layer surface. The thermal and mechanical contact of the