AC surface flashover strength and barrier effect of LN2 for HTS transformer with simulated electrode
✍ Scribed by Jong-Man Joung; Seung-Myeong Baek; Hae-Jong Kim; Sang-Hyun Kim
- Book ID
- 104112378
- Publisher
- Elsevier Science
- Year
- 2003
- Tongue
- English
- Weight
- 365 KB
- Volume
- 43
- Category
- Article
- ISSN
- 0011-2275
No coin nor oath required. For personal study only.
✦ Synopsis
In the response to an increasing demand for electrical energy, much effort aimed to develop and commercialise HTS power equipments is going on around the world. For the development, it is necessary to establish the dielectric technology in LN 2 . Hence many types of dielectric tests should be carried out to understand the dielectric phenomena at cryogenic temperature and to gather various dielectric data. Among the many types dielectric tests, the characteristic of surface flashover and the barrier effect were conducted with the simulated electrode after analysing the insulating configuration of the pancake-coil-type HTS transformer. The influence of a barrier on the dielectric strength was measured according to the size of the barrier, the position of the barrier and the effect of the back-electrode. It was shown that the effectiveness, namely the ratio of the breakdown voltage in presence of barrier to the voltage without barrier, is highest when the barrier is placed at the needle electrode side. The effect increased up to 1.8 times when collar length is 10 mm. The flashover characteristic with back-electrode was remarkably lower than the characteristic without one in the case the electrodes located at the same surface of dielectric plate. On the contrary, in the case the barrier was placed between the electrodes, the characteristic was even improved slightly.