## Abstract Compact circularly polarized single feed microstrip antenna using fractal curve as boundary is presented. It is shown that by using fractal curve as boundary to the square patch the size can be reduced by more than 50% without much reduction in gain of the antenna. The antenna gives a g
A T-type fractal boundary single-feed circularly polarized microstrip antenna
β Scribed by P. Nageswara Rao; N. V. S. N. Sarma
- Publisher
- John Wiley and Sons
- Year
- 2009
- Tongue
- English
- Weight
- 578 KB
- Volume
- 19
- Category
- Article
- ISSN
- 1096-4290
No coin nor oath required. For personal study only.
β¦ Synopsis
A single-feed T-type fractal boundary microstrip antenna is presented. It is established that a very good circular polarization is realizable with 3-dB axial ratio bandwidth of 1.27% at the center frequency of 2446 MHz by changing the electrical length in two directions of the square patch by using T-type fractal curve as boundary. Further it is shown that the surface area occupied by the antenna is reduced compared to the Euclidean shaped patch antenna without much degradation in gain of the antenna. Experimental results are compared with simulated results and a very good agreement is obtained. V
π SIMILAR VOLUMES
## Abstract A single feed circularly polarized Minkowski fractal boundary microstrip antenna is presented. By changing the fractal dimension of the boundary in both the directions of the antenna it is established that a very good circular polarization with 3 db axial ratio bandwidth of about 1.4% i
A single feed circularly polarized fractal boundary microstrip antenna with improved axial ratio bandwidth is presented. The low-axial ratio bandwidth of single feed circularly polarized microstrip antenna is due to its probe reactance. In this article, the inherent disadvantage of this low-AR bandw
## A new and simple technique for obtaining circular polar-( ) ization CP radiation of a single-feed microstrip antenna is demonstrated. This CP design is achie¨ed by insetting a single slit to the boundary of the microstrip patch, and placing a single feed along an axis 45Рto the one containing
This paper presents an analysis method of a singlefeed circularly polarized microstrip antenna (MSA) by means of the boundary element method. When the boundary element method is applied to such open planar circuits as the microstrip antenna, the loss due to radiation must be taken into consideration
Figure 10 Loci of frequency and location versus distance where double nulls and strong double dips are occurring for x s y10 m in s Ε½ . Ε½ . the lossless dielectric media of β s 1.8, 2, 3. a Frequency. b r Location dip separation distance converges to the cavity size as the source point approaches th